MINI RF4 V2: How To Position & Mount

Introduction
This guide will show you how to properly position and mount your Rockville MINI RF4 V2 lights for optimal coverage and effect. Whether you want to create a vibrant wall wash, highlight a totem stand or mount to a truss system, these instructions are simple and beginner-friendly.
Requirements
✅Rockville MINI RF4 V2 Four-Pack (available in White or Black)
✅Rockville LC70 or Similar Lighting Clamp (if mounting to a truss or pole)
✅Totem Stand (optional)
✅Lighting Stand or Truss (optional)

Guide to Positioning & Mounting

A.) Using the Built-in Bracket for Wall Washing

• Each MINI RF4 V2 light comes with a built-in bracket that can be utilized when placing on the floor for wall-washing / up-lighting:
  1. Loosen the side knobs to adjust the angle.
  2. Tilt the light to the desired position.
  3. Tighten the knobs to lock it in place.
• You can tilt the light at various angles to aim it toward a wall from a few inches away.
• This angled setup is ideal for creating a wall washing effect by spreading light evenly across the surface.

B.) Using the Built-in Feet for Wall Washing

• The built-in feet on the bottom of each light allow for stable placement on the floor, against a wall or inside a totem stand.
• Place the light directly against a wall or DJ facade with the feet down for a strong upward beam.
• This works well for accent lighting on walls, drapes or event backdrops.

C.) Placing Inside a Totem Stand
The feet also allow the Mini RF4 V2 lights to fit securely inside a totem stand to create a glowing effect inside.

• Position the MINI RF4 V2 light inside a totem stand to illuminate it from within:
  1. Lift the scrim of your totem stand.
  2. Place the Mini IR4 inside, facing upwards.
  3. Set your desired color or mode on the light.
  4. Lower the scrim back down.
• This is perfect for enhancing the look of stage setups or DJ booths.

D.) Mounting to a Truss (or Speaker Stand Pole) Using the Bracket and Clamp

• Identify the central hole on the light’s bracket.
• Use a compatible lighting clamp (like the Rockville LC70).
• Attach the lighting clamp:
  1. Unscrew the clamp’s bolt and align it with the hole in the bracket.
  2. Insert the bolt through the hole in the bracket.
  3. Screw the clamp onto the bracket.
• Place the light on your truss or lighting / speaker stand pole:
  1. Loosen the clamp knob (a.k.a butterfly screw) to open it wider than truss / pole diameter.
  2. Position the clamp on the truss / pole where you want the light.
  3. Tighten the knob to secure the light to the truss.
  4. After mounting, the light can be tilted for precise lighting of the stage / performer.

FAQs

What type of lighting clamp should I use?
✅We recommend using a standard lighting clamp like the Rockville LC70 for secure and safe mounting.

Can I point the light downward from a truss?
✅Yes, the bracket allows flexible angling. 
✅You can direct the beam up, down or at any angle required for your setup.

Conclusion

Positioning your Rockville MINI RF4 V2 lights is quick and flexible—whether you're going for a wall wash, totem lighting, or truss-mounted effects. With the built-in bracket and feet, plus truss-mounting capability, you can tailor the setup to any event or venue.