Introduction
Setting up your Pixel Hybrid Bar Lights inside the Pixel Hybrid Charging Case is simple and ensures your lights stay organized and charged, ready for your next event. This guide will walk you through the easy process of charging your lights inside the case.
Step 1: Gather the Necessary Cables
Before you begin, ensure you have the following:
- Power cables for each light.
- Main power cable for the case.
Step 2: Plugging in the Lights
- Locate the Power Outlets:
- On the side of the case, you’ll notice several outlets. These are where you will plug in each light.
- Connect the Power Cables:
- Take the blue end of the power cable and plug it into the power-in socket of each light.
- Then, plug the other end of the cable into each outlet on the side of the case.
Step 3: Powering the Case
- Locate the IEC Power Socket:
- On the outside of the case, you’ll see an IEC socket. This is where you’ll plug in the main power cable to charge the entire case.
- Connect the Main Power Cable:
- Take the IEC end of your power cable and plug it into the IEC socket on the case.
- Plug the other end of the power cable into a wall outlet or power source.
- Flip the Power Switch:
- To begin charging the lights, flip the switch on the case to the on position.
Step 4: Charging the Lights
- Charging Time:
- If the lights are completely dead, they usually take about 6 hours to fully charge.
- Check Battery Life:
- To check the battery life on each light, turn them on and check the battery life indicator on the top of the lights.
- Proper Ventilation:
- We recommend leaving the case open while charging to ensure the lights receive proper ventilation during the charging process.
Conclusion
Setting up your Pixel Hybrid Bar Lights in the Pixel Hybrid Charging Case is quick and easy. Simply plug in the power cables, connect the main power cable to the case, and flip the switch to begin charging.
Comments
0 comments
Article is closed for comments.