WET PAR WC: How To Position

Introduction

This article provides a step-by-step guide on how to position your Rockville Wet Par WC light. The instructions are simple and easy to follow, even if you have no technical experience. You will learn about the different ways to angle and mount your light, as well as the tools you may need for mounting.

Requirements:
✅Rockville WET PAR WC (available in Black or White)
✅For Mounting ~ Truss or Lighting/Speaker Stand
✅For Mounting ~ Rockville LC70 or Similar Lighting Clamp

Step-by-Step Instructions:

A.) Adjusting the Angle Using the Bracket

• Locate the bracket at the bottom of your Wet Par WC light.
• The bracket has a leg and a middle piece that lines up with ridges along the middle of the light.
• To set the angle:
  1. Line up the middle piece of the bracket with any of the ridges on the light.
  2. Place the light down at your desired angle. 
     • The bracket will hold the light steady.
  3. Use different ridges to adjust the angle further as needed.

B.) Mounting the Light with a Lighting Clamp

• The Wet Par WC light has threading on the bottom for attaching a lighting clamp like the Rockville LC70.
• To mount the light:
  1. Remove the nut from the bottom of your lighting clamp.
  2. Line up the clamp’s bolt with the threading on the light.
  3. Screw in the bolt to secure the clamp to the light.
• With the clamp attached:
  4. Loosen the butterfly screw on the clamp.
  5. Position the light on your truss or stand at the desired spot.
  6. Tighten the butterfly screw to secure the light in place.

Troubleshooting & FAQs

Can I use the light without a clamp?
✅Yes, you can use the bracket and ridges to set the light at different angles on any flat surface.

The light does not stay placed at the angle I want.
✅Ensure the light is placed on a stable surface.
✅Make sure the bracket’s middle piece is properly lined up with one of the ridges.

The clamp feels loose or unstable when mounted.
✅Double-check that the bolt is fully screwed in and the clamp is tightly secured.
✅Make sure the butterfly screw is tightened after positioning the light.

Conclusion

Your Rockville Wet Par WC light is powerful and flexible, whether you want to set it at an angle on the ground or mount it on a truss or stand. Rockville gives you the tools to maximize your lighting setup, with these instructions, as well an array of optional mounting accessories. For questions about getting the right mounting accessories or any part of this guide, please Contact Rockville Tech Support for further assistance.