How To Set Up a Microphone with Your Rockville Elite Five Speakers

Introduction:

This article will guide you through the process of connecting and configuring a microphone with your Rockville Elite Five speakers. The steps are straightforward and suitable for users of all experience levels. All you need is your Elite Five speaker system, a dynamic microphone, and a female XLR to quarter-inch cable.

Step-by-Step Instructions

1. Understanding Microphone Inputs
   • The Elite Five speakers have two microphone inputs on the back, allowing you to connect up to two microphones at once.
2. Connecting Your Microphone
   • Obtain a dynamic microphone and a female XLR to quarter-inch cable.
   • Plug the female XLR end into your microphone.
   • Insert the quarter-inch end into either of the microphone inputs on the back of the Elite Five. You can use either input; for this example, use microphone input one.
3. Adjusting Microphone Settings with the Mic Menu Controls
   • Use the mic menu controls on your speaker to adjust microphone settings.
   • Press the menu button to cycle through the following settings:
     • T (Treble): Adjusts the high frequencies of the microphone.
     • B (Bass): Adjusts the low frequencies of the microphone.
     • E (Echo): Sets the amount of echo effect on your voice.
     • D (Delay): Controls how many times the echo repeats. For a quick slap-back effect, set D to around three or four. For more delay, increase the D setting.
     • OV (Volume): Adjusts the microphone volume.
   • Alternatively, you can use the up and down arrow buttons to adjust the microphone volume directly, without entering the menu.
4. Testing Your Microphone
   • After adjusting the settings, turn on your microphone and speak into it. Your voice should be heard through the speakers.
5. Setting Up a Second Microphone
   • To connect a second microphone, repeat the same steps as above.
   • Note: All settings adjusted using the mic menu controls will apply to both microphones.

Troubleshooting & FAQs

Q: My microphone is not producing sound.

• Ensure the cable is securely connected to both the microphone and the speaker.
• Check that the microphone is powered on (if applicable).
• Make sure the microphone volume is turned up using the mic menu controls or arrow buttons.

Q: The echo or delay effect is too strong or weak.

• Use the mic menu controls to adjust the E (Echo) and D (Delay) settings to your preference.

Q: Only one microphone is working.

• Confirm both microphones are properly connected.
• Try each microphone in both inputs to rule out a faulty cable or input.

Conclusion

Setting up a microphone with your Rockville Elite Five speakers is quick and easy. With just a few connections and simple adjustments, you’ll be ready to use one or two microphones for your events or performances.