How To Set Up Your ROCKBOOTH PRO PACK

Introduction

This article will guide you through setting up your ROCKBOOTH PRO PACK, an all-in-one DJ booth solution. The instructions are simple and easy to follow, even if you have no technical experience. By the end, you’ll have your booth ready for use with dual tables, a TV mount, truss, and scrims.

Requirements:

• ROCKBOOTH PRO PACK (all included parts)
• Basic hand-tightening (no special tools required)
• Compatible TV (for mounting, if desired)

Step-by-Step Instructions

1. Unpack and Prepare

Step 1: Unpack the Bags

• The booth comes in two bags containing all components.

Step 2: Open the Booth Frame

• Unfold the booth frame fully to its standing position.

2. Assemble the Tables

Step 3: Attach the Lower, Larger Table

• Place the lower table onto the booth frame.
• Use the 4 included round-top bolts to secure it.

Step 6: Attach the Top Table

• Place the top table on the booth after covering it with the scrim (see below).

3. Install the TV Mount

Step 4: Install TV Mount

• Use the 4 included bolts, wing nuts, and washers.
• Insert each bolt through the front of the facade.
• Place a washer and nut on the back of each bolt.
• Secure all four corners of the TV mount.

Step 5: Attach the Legs

• Attach one leg to each side of the booth using 2 bolts, washers, and wing nuts per side.
• Adjust the rubber feet to level the booth.

5. Cover the Booth

Step 6: Cover the DJ Booth with a Scrim

• Choose either the white or black scrim.
• Fix the booth cloth in place using the ribbons and Velcro.
• Use the zippers to access the TV mount if needed.

6. Build the Truss

Step 7: Build the Truss

• Attach truss stands to the booth using two hand-tightening knobs and nuts per side.
• Use Velcro on the booth cloth for a cleaner look.
• Connect the two truss poles together using a bolt and wing nut in the middle (use included hardware).
• Loosen the bolt of the pole attachment and place the truss on top of the stands.
• Fasten it using the hand screws.
• Loosen the middle screws on the stands to adjust the height of the truss.
• Use the locking pin to fix the height, then tighten the bolt to secure it.
• Use the included hardware to attach your lighting gear to the truss.

7. Mount Your TV

Step 8: Mount Your TV Securely

• Use the included hardware to attach the TV to the mount.
• Secure your TV using the bolt on the back side of your booth.

8. Cable Management

• Run your cables via the cable-management ports for a tidy setup.

Troubleshooting & FAQs

Q: The booth feels unstable. What should I do?

• Ensure all bolts, nuts, and wing nuts are tightened securely.
• Adjust the rubber feet to level the booth on uneven surfaces.

Q: The TV mount doesn’t fit my TV.

• Check your TV’s mounting compatibility with the included hardware.
• Use washers and bolts as shown to ensure a secure fit.

Q: The truss is not level or won’t stay at the desired height.

• Double-check that the locking pin is inserted and the bolts are tightened.
• Adjust the middle screws for height and secure them firmly.

Q: The scrim is loose or uneven.

• Use all provided Velcro and ribbons to secure the scrim tightly around the frame.

Conclusion

You have now set up your ROCKBOOTH PRO PACK DJ booth, complete with tables, TV mount, truss, and scrims.