CCL6T: How To Set Up, Wire & Install

Introduction

This article guides you through the simple and straightforward process of installing and setting up your CCL6T 70 Volt Commercial Ceiling Speakers. Whether you have these speakers in black or white, the setup process remains identical. No technical experience is needed—just follow the easy steps below.

Requirements:

• CCL6T 70 Volt Commercial Ceiling Speakers (included in box: 4 speakers)
• 70 Volt amplifier (matching your speaker wattage needs)
• Speaker wire
• Cutout guide (included in the package)
• Tape (optional, for ease)

Step-by-Step Instructions

Step 1: Understanding 70 Volt Systems

Your CCL6T speakers use a 70 Volt audio system, allowing multiple speakers to connect to a single amplifier.

• Example: If your amplifier is 100 watts, you can connect up to 20 speakers tapped at 5 watts each (100 watts ÷ 5 watts per speaker = 20 speakers).

Step 2: Preparing Your Ceiling for Installation

1. Use the included paper cutout guide to mark the location on your ceiling tile or sheetrock ceiling.
2. Use tape to secure the guide if needed.
3. Cut out the marked hole carefully, following the guide with a blade.

Step 3: Installing the Speaker

1. Push spring retainers on the speaker upwards and insert the speaker into the hole.
2. Ensure the speaker sits firmly and flush with the ceiling surface.

Step 4: Connecting Your Speaker Wiring

Each speaker has terminals for connection:

• Negative wire (black): Connect to the negative or "common" terminal.
• Positive wire: You have three options for customizing the wattage per speaker:
  • 10 watts
  • 5 watts
  • 2.5 watts

Example:To use a 50-watt amplifier with ten speakers, you could tap each speaker at 5 watts.

Step 4: Parallel Wiring Your Speakers (Daisy Chaining)

You can connect multiple speakers using parallel wiring (daisy chaining), connecting them sequentially:

1. Connect the first speaker:
   • Connect the negative wire to the common terminal.
   • Connect the positive wire to your chosen wattage tap (e.g., 5 watts).
2. Connect the second end of the wire from the first speaker to the same terminals (negative and 5 watts) on the second speaker.
3. Repeat the process for each additional speaker, chaining them together.

Step 5: Connecting to the Amplifier

Once you've daisy-chained all speakers:

• Connect the final speaker to your 70 Volt amplifier.
  • Negative wire to the amp’s common terminal.
  • Positive wire to the 70 Volt positive terminal or to one of the amp’s zone outputs.

Troubleshooting & FAQs

Q: What if my speakers don't produce sound?

• Verify all wiring connections are secure, particularly the polarity (negative to negative, positive to correct watt tap).
• Ensure your amplifier is powered and set to output 70 volts.

Q: Can I mix wattages across different speakers?

• Yes. You can customize wattages based on your desired volume levels in different areas.

Q: How many speakers can my amplifier handle?

• Divide the total amplifier wattage by the watt tap of each speaker to determine your maximum number.

Conclusion

Installing and wiring your CCL6T 70 Volt Commercial Ceiling Speakers is straightforward with these easy-to-follow steps. Be sure to verify your connections carefully and choose appropriate wattage taps based on your amplifier and speaker quantity.