R-GO: Quick Start Setup Guide

Introduction: 

This guide will walk you through the simple steps to get your Rockville R-GO portable speaker up and running. Whether you're new to Bluetooth speakers or just need a quick refresher, this article covers everything from powering on the speaker to linking two units for stereo sound. No technical experience needed!

What You’ll Need:

• A Rockville R-GO portable speaker (charged or connected to power)
• A smartphone, tablet, or Bluetooth-enabled device
• Optional: Second R-GO speaker for stereo pairing, TF card, mic stand, or carabiner/lanyard

Step-by-Step Instructions

1. Power On the Speaker

• Locate the power button on the side of the speaker.
• Press and hold the power button until the speaker turns on.

2. Use the Control Buttons

• Play Button
  • Tap to play/pause music.
  • Tap to answer or end calls when connected to a phone.
  • Double-click to activate TWS (True Wireless Stereo) linking mode (covered in Step 7).
• Volume + / - Buttons
  • Tap + to raise volume, hold + to skip to the next track.
  • Tap – to lower volume, hold – to go to the previous track or the beginning of the current track.

3. Charge the Speaker or Connect to a Computer

• Open the protective cover at the bottom to access the USB-C port.
  • Use this port to charge the speaker or connect to a laptop/computer.

4. Play Music from a TF Card

• Insert a TF card into the TF card input (located next to the USB-C port).
• The speaker will automatically start playing files stored on the card.

5. Mount or Carry the Speaker

• Use the built-in mount to attach the speaker to a bar or mic stand.
• Or detach it and use the included carabiner or lanyard for portability.

6. Pair with a Bluetooth Device

• On your phone or tablet, go to Bluetooth settings.
• Look for the device name “R-GO” and tap to connect.
• Once paired, you’ll hear a sound confirmation.

7. Pair Two R-GO Speakers with TWS

• Make sure both speakers are turned off and disconnected from any Bluetooth devices.
• Power on both speakers at the same time.
• On one speaker, double-click the play button to initiate TWS linking.
• Wait for the confirmation sound indicating both speakers are connected.
• Connect your Bluetooth device to one of the speakers—both will now play audio in sync.

Troubleshooting & FAQs

Q: My speaker won't turn on. What should I do?

• Make sure it’s charged. Connect it to power using the USB-C port and try again.

Q: The speaker isn’t showing up in Bluetooth.

• Ensure it’s in pairing mode and not already connected to another device. Turn it off and back on, then retry pairing.

Q: How do I reset the TWS pairing?

• Power off both speakers, disconnect any Bluetooth devices, then repeat the TWS pairing steps.

Q: Can I use the speaker while it’s charging?

• Yes, you can play audio while charging via USB-C.

Conclusion:

Now you’re ready to enjoy powerful, portable audio with your Rockville R-GO speaker. Whether you're pairing with your phone or linking two units for stereo sound, setup is simple and quick.