RHT28D: How To Set Up & Use

Introduction

The Rockville RHT28D Speaker Stands are designed for studio monitors and home audio setups, offering stability, sound isolation, and cable management. This guide will walk you through step-by-step assembly instructions to ensure your stands are set up correctly.

What’s Included

• 2 Columns (Main structure of the stands)
• 2 Base Plates (Bottom of each stand)
• 2 Sets of Top Plates:
  • Small top plates (For smaller speakers)
  • Large top plates (For larger speakers)
• Rubber Feet (For hardwood floors)
• Spikes (For carpeted floors)
• Sound Isolation Pads (Optional, prevents scratches and improves stability)
• Wire Management Clips & Zip Ties (For an organized setup)
• Screws & Hardware (For securing the plates to the stands)

Step-by-Step Assembly

1. Attach the Base Plates

1. Flip each column upside down.
2. Locate the pre-drilled holes on the base plate (indicated by small puncture marks).
3. If needed, insert a screw through the holes to better align them with the column.
4. Align the base plate with the column holes.
5. Insert four screws through the holes.
6. Use a screwdriver or drill to securely attach the base plate.
7. Repeat these steps for the second stand.

2. Install the Feet (Choose Rubber Feet or Spikes)

• Rubber Feet (For Hardwood Floors):
  • Line up the rubber feet screws with the holes on the corners of the base.
  • Screw them in securely.
• Spikes (For Carpets/Rugs):
  • Line up the spikes with the screw holes on the base.
  • Screw them in loosely if you need to level the stands on uneven carpets.

Repeat the process for both stands.

3. Optional: Add Sand for Extra Stability

• The columns are hollow, allowing you to add sand inside for additional weight and stability.
• This step is optional but recommended for added support.

4. Attach the Top Plates

• Choose the appropriate top plate size:
  • Small Top Plates (For smaller speakers)
  • Large Top Plates (For larger speakers)

1. Locate the pre-drilled holes on the top plate.
2. If needed, puncture holes through the protective film using a screw.
3. Align the top plate with the column holes.
4. Insert four screws through the holes.
5. Use a screwdriver or drill to secure the plate.
6. Repeat for the second stand.

5. Attach the Sound Isolation Pads (Optional)

1. Remove the adhesive backing from each foam pad.
2. Place the pads on the corners of the top plate.
3. If needed, adjust placement to better fit your speakers.

6. Install Wire Management Clips (Optional)

1. Remove the adhesive backing from each clip.
2. Choose the best placement for your setup:
   • One clip near the top of the column
   • One clip near the base
3. Press the clips firmly onto the column and/or base.
4. Run the speaker wires through the clips for a clean, organized setup.
5. Use zip ties to secure larger cables if needed.

7. Place Your Speakers on the Stands

• Carefully place your speakers onto the top plates.
• Ensure the sound isolation pads are properly supporting the speakers.
• Adjust the wire management as necessary.

Conclusion

Setting up your Rockville RHT28D Speaker Stands is quick and easy, offering stable support, sound isolation, and wire management for a professional setup. By following these steps, you’ll have your speakers securely mounted and optimized for the best performance.