SS28 | SS36: How To Set Up & Use

Introduction:
This guide will walk you through how to assemble your Rockville SS speaker stands quickly and easily—no matter the size or color. The SS stand series comes in two sizes (28" and 36") and three finishes (Black, Dark Wood, Classic Wood). Setup is the same across all versions. You don’t need any technical experience—just follow the steps below.
Requirements: A screwdriver or drill (optional, but helpful).

Step-by-Step Instructions

1. Unbox and Identify Parts

Your speaker stand package includes:

• 2 top plates (1 small, 1 large per stand)
• 2 bottom base plates
• 2 stand bodies
• 16 screws
• 8 foam pads
• 8 rubber feet
• 8 brass carpet spikes (grass feet)
• Wire management clip(s)
• Zip ties

2. Understand the Orientation

• Each stand tapers from thin at the top to thick at the bottom.
• The thinner end is for the top plate, and the thicker end is for the base plate.

3. Install the Bottom Plate

• Turn the stand upside down so the thick end faces up.
• Align the dents on the bottom plate with the pre-drilled holes on the stand.
• Insert 4 screws through the plate dents and tighten using a screwdriver or drill.

4. Attach the Feet

• Choose between:
  • Rubber feet for most floor types
  • Brass feet for carpeted surfaces
• Screw one foot into each corner of the bottom plate.

5. Install the Top Plate

• Choose the large or small top plate based on your speaker size.
• Line up the dents on the top plate with the screw holes on the top of the stand.
• Insert screws and tighten to secure the plate.

6. Apply Foam Pads

• Determine where the corners of your speakers will sit.
• Peel off the backing from the foam pads to reveal the adhesive.
• Stick the pads to the top plate where they align with your speaker corners.
• Press firmly to secure.

7. Attach Wire Management Clips

• Peel off adhesive backing and place clips on the back of the stand.
• Use one at the top and one at the bottom (or more if desired).
• For thin speaker wire, thread it through the hoops in each clip.
• For thick wire, run zip ties through the side hoops to hold the wire in place securely.

Troubleshooting & FAQs

Q: My plates don’t have pre-drilled holes. Is that normal?
A: Yes. Instead of holes, there are indentations (dents) that show you exactly where to screw.

Q: How do I decide between rubber and brass feet?
A: Use rubber feet for wood, tile, or concrete floors. Use brass carpet spikes if placing on thick carpet for better stability.

Q: My speaker size doesn’t match the foam pad placement. What should I do?
A: Simply adjust the foam pad placement based on your speaker’s dimensions before securing.

Conclusion

That’s all there is to it! With just a few tools and these easy steps, you’ll have your Rockville SS speaker stands assembled and ready for use.