R720L V2: How To Set Up Fog / Smoke Machine with Remotes & Multi Color LED

Introduction

This guide will walk you through the simple and quick setup process for the Rockville R720L V2 Fog Machine. Whether you're using it for a DJ event, stage performance, or party, the steps below are easy to follow—even if you’ve never used a fog machine before.

What’s Included:

• R720L V2 Fog Machine
• Wired Remote
• Wireless Remote
• Power Cable
• Carrying/Mounting Handle
• Small container of Rockville Fog Fluid

Requirements:

• Access to a power outlet
• Rockville fog fluid (included for initial setup; more can be purchased separately)

Step-by-Step Instructions

1. Set Up the Machine

• Place the machine on a flat surface using the rubber feet, or use the included handle to mount it on a truss or lighting rig.
• To attach the handle:
  • Position it between the screws and washers on each side of the unit.
  • Tighten the screws until secure.

2. Fill with Fog Fluid

• Unscrew the top gasket cap.
• Pour in the included fog fluid using the built-in fluid level indicator as a guide.
• Re-tighten the gasket cap securely.

3. Connect the Wired Remote

• Plug the male connector of the wired controller into the port labeled "Manual Controller."

4. Power On and Warm-Up

• Plug in the machine using the provided power cable and switch it on.
• Allow approximately 3 minutes for the unit to warm up.
• The wired remote’s light will turn on once the machine is ready.

Operating the Machine

Using the Wired Controller:

• Press the button to release fog.
• Each activation emits 30 seconds of fog, followed by a cool-down period.
• You’ll know the machine is ready again when the remote’s light turns back on.

Tip: For a haze effect, release fog in 5-minute intervals to create an ambient room fill.

Using the Wireless Controller:

Note: The wireless controller only works when the wired controller is plugged in.

• The wired controller is magnetized and can be stored on the side of the machine for convenience.

Wireless Remote Functions:

• To strobe in a specific color:
  • Select a static color using Button 3, then press Button 1 to strobe that color.
• To stop fog output:
  • Press Button 4 again.

Maintenance Tips

• After Use:
  • Unscrew the gasket and use either remote to release any remaining fog fluid inside the tubing. This prevents clogging.
• Monthly Cleaning:
  • Empty the tank.
  • Fill with vinegar.
  • Activate the fog function to flush the machine.
  • This helps maintain performance and longevity.
• Fog Fluid Refills:
  • You can purchase additional premium Rockville fog fluid as needed.

Troubleshooting & FAQs

Q: Why is the wireless remote not working?
A: Ensure the wired controller is plugged in—it's required for wireless control.

Q: Why does the fog stop after 30 seconds?
A: The machine automatically cools down after each burst. Wait for the controller light to turn back on before using again.

Q: The machine isn’t releasing fog. What should I do?

• Make sure the machine has warmed up (about 3 minutes).
• Confirm fluid is in the tank and the gasket is closed properly.
• Check that the wired remote is securely connected.

Conclusion

Setting up the Rockville R720L V2 Fog Machine is quick and easy. With both wired and wireless control options, sound-activated lighting effects, and thoughtful design features like a fluid level indicator and magnetic remote, it’s ready to elevate your events.