Z45W | Z55: How To Set Up

Introduction:

This guide will walk you through the simple and easy setup process for the Rockville Z-Series two-tier Z-style keyboard stands, including the Z55 and Z45W models. Whether you're a beginner or a seasoned performer, you'll find the steps straightforward. The only difference between these models is that the Z45W includes wheels for mobility.

Requirements:

• Rockville Z55 or Z45W Keyboard Stand (includes legs, arms, middle bar, butterfly screws, washers, and travel bag)
• Phillips head screwdriver (optional, if needed for keyboard mounting)

Step-by-Step Instructions:

1. Prepare Your Hardware

• Identify and lay out all included parts:
  • 2 Z-style legs
  • 2 second-tier arms
  • 1 middle bar
  • 2 butterfly screws with washers
• Slide each washer onto a butterfly screw and set them aside.

2. Attach the Middle Bar

• Align the holes at each end of the middle bar with the corresponding holes on the Z-legs.
• Insert a butterfly screw (with washer) through the holes and tighten securely on both sides. This stabilizes the base.

3. Install the Second-Tier Arms

• Remove the pre-installed butterfly screws near the top of the legs.
• Slide each arm into the slot on each leg.
• Ensure the holes on the bottom of the arms align with the holes on the stand.
• Reinsert the butterfly screws and tighten to secure both arms.

4. Adjust the Stand Width

• Remove the butterfly screw in the center of the middle bar.
• Pull the legs apart to the desired width based on your keyboard size.
• Align one of the holes on the middle bar with the hole on the upper bracket.
• Reinsert and tighten the butterfly screw to lock in the width.

5. Adjust the Second Tier Height

• Remove the butterfly screws below the arms.
• Raise or lower the arms to your desired height.
• Make sure the holes are aligned.
• Reinsert and tighten the butterfly screws to lock the height in place.

6. For Z45W Users: Using the Wheels

• To move the stand, simply lift the brake tabs on the wheels.
• Roll the stand to your desired location.
• Press the brake tabs back down to lock the wheels and secure the stand.

7. Add Your Keyboards

• Place your keyboards on the bottom and top tiers.
• Use the included security pins to fasten your keyboard (only if your keyboard has matching screw holes).

8. Accessory Hook and Travel Bag

• Use the side hook for hanging headphones, cables, or other gear.
• When done, disassemble the stand and store it in the included travel bag for easy transport to gigs or events.

Troubleshooting & FAQs

Q: My keyboard doesn’t have screw holes for the security pins. Can I still use the stand?
A: Yes, the stand will still securely hold your keyboard using the arms alone, but the security pins add extra stability if compatible.

Q: The stand feels loose after adjusting the width or height.
A: Make sure all butterfly screws are tightened securely and that holes are aligned properly before locking into place.

Q: Can I use this stand for other equipment besides keyboards?
A: While designed for keyboards, the sturdy design may support other gear like mixers or DJ controllers if they fit safely on the tiers.

Conclusion:

Setting up your Rockville Z-Series keyboard stand is quick and hassle-free, with adjustable width and height, second-tier support, and portable features like wheels and a travel bag.