Introduction
The Rockville HC-85 Ceiling Speakers are designed to provide high-quality sound in a ceiling-mounted setup. Whether you're installing them in sheetrock or ceiling tiles, the process is straightforward and simple. Follow the easy steps below to install your HC-85 speakers.
What You’ll Need
- Rockville HC-85 Ceiling Speakers
- Paper cutout guide (included)
- Blade (not included) for cutting the ceiling tile
- Grille remover tool (included)
- Phillips screwdriver
- Wiring for connection to an amplifier or receiver
- Amplifier or receiver with 8-ohm support
Step-by-Step Instructions
1. Prepare the Ceiling Tile
- Take the included paper cutout guide and place it on your ceiling tile.
- Use a blade to carefully cut along the guide, creating a hole for the speaker.
2. Remove the Speaker Grille
- Use the grille remover tool (included) to remove the grille from the speaker.
- Once the grille is removed, you’ll see four Phillips screws on the speaker.
3. Place the Speaker
- Position the speaker through the hole in your ceiling tile.
- Tighten the four screws with a Phillips screwdriver to pull the speaker securely into place in the ceiling tile.
4. Wire the Speaker
- The speaker has red and black push terminals for easy wiring.
- Push the terminals to open them, insert the speaker wires, and release to lock them in place.
5. Install the Speaker in the Ceiling
- Once the speaker is wired, place the tile with the speaker into your ceiling.
- Ensure the speaker is securely mounted and connected to your amplifier or receiver.
6. Connect to Amplifier or Receiver
- Run the wire from your speaker to your amplifier or receiver.
- These speakers are rated 8-ohms, so you can connect two speakers to each channel if your amplifier or receiver is 4-ohm stable.
Conclusion
Installing your Rockville HC-85 Ceiling Speakers is easy and quick, providing excellent sound quality for your space.
Comments
0 comments
Article is closed for comments.