ROCKON-7: How To Position & Mount

Introduction

Properly positioning your Rockon 7 moving headlight is essential for optimal performance in events, DJ setups, and stage productions. This guide will walk you through different placement options and show you how to mount the light securely to a truss or stand.

What You'll Need

• Rockon 7 Moving Headlight
• Power cable (included)
• Mounting bracket (included)
• Lighting clamp (e.g., Rockville LC70)
• Screwdriver or drill
• Totem stand or truss (optional)

Placement Options

1. Table or Flat Surface

• Easiest setup – Simply place the light on a flat, stable surface.
• Great for DJ booths, small events, and home use.
• Ensure proper ventilation to prevent overheating.

2. Totem Stand Setup

• If using a totem stand, remove the 35mm pole mount to make space.
• Place the light directly on top of the stand for a clean and professional look.
• Ensure the stand is stable and level to prevent tipping.

3. Truss Mounting for Stage & Large Events

To suspend the Rockon 7 moving headlight from a truss, follow these steps:

How to Mount the Rockon 7 to a Truss

Step 1: Attach the Mounting Bracket

1. Locate the screw holes on the bottom of your light.
2. Use a screwdriver or drill to remove the screws.
3. Align the included mounting bracket to the screw holes on the light.
4. Secure the mounting bracket by reinstalling the screws.

Step 2: Attach the Lighting Clamp

1. Take your lighting clamp (LC70 or similar).
2. Remove the wing nut and loosen the bolt.
   • Pro Tip: If the bolt is tight, use a wrench to loosen it.
3. Align the middle hole on the mounting bracket with the hole on the clamp.
4. Run the bolt through both holes and reinstall the wing nut for security.

Step 3: Mount to a Truss

1. Loosen the butterfly screw on the clamp.
2. Align the clamp with an open section of your truss.
3. Tighten the butterfly screw to secure the light.

Powering On & Final Adjustments

1. Connect the Power Cable:
   • Plug the female end into the back of the Rockon 7.
   • Plug the other end into a power outlet or power strip.
2. Adjust the Positioning:
   • Tilt and pan the moving head to the desired position.
   • Use preset modes or DMX control for advanced lighting effects.

Conclusion

By following these steps, you can easily position and mount your Rockon 7 moving headlight for stable and professional lighting effects. Whether you're placing it on a table, stand, or truss, ensure it’s secure and powered correctly.