DX15: How To Set Up & Use

Introduction

In this guide, we'll walk you through setting up your Rockville DX15 Powered PA Speaker for various applications. Whether you're using it as a standalone speaker, a stage monitor, or integrating it into a larger sound system, these steps will help you get started quickly and easily.

What's Included

• DX15 Powered PA Speaker
• Power Cable

Mounting the Speaker

The DX15 offers multiple mounting options to fit different setups:

Using a Speaker Stand

1. Choose a pole mount option – The DX15 has two 35mm pole mounts:
   • One mount angles the speaker slightly downward.
   • The other keeps it straight.
2. Lift and align the speaker – Carefully lift the speaker and position the mount over the speaker stand.
3. Secure the speaker – Push the speaker down onto the stand until it is fully seated.

💡 Tip: If the speaker is too heavy, have someone assist you during setup.

Floor or Table Placement

• Place the speaker upright using the rubber feet for stability.
• Lay the speaker on its side to use it as a stage monitor.

Ceiling or Wall Mounting

• The DX15 has fly points at the top, middle, and bottom for rigging.
• Use a flathead screwdriver to remove the fly point covers before installing.

Connecting Audio Sources

Using a Microphone

1. Plug your microphone into the Mic Input on the back of the speaker.
   • The input supports both XLR and ¼-inch (6.35mm) cables.
2. Raise the Mic Volume Knob and Master Volume Knob.
3. Turn on the microphone and test your sound.

Using Line-Level Sources (Mixers, Instruments, Additional Speakers)

1. Plug your line-level source (e.g., mixer, instrument) into the Line Input.
   • The combo jack supports both XLR and ¼-inch cables.
2. Adjust the Line Volume Knob and Master Volume Knob.

Adjusting Sound with the Built-in EQ

• Bass Knob: Controls low-end frequencies.
• Treble Knob: Controls high-end frequencies.

Expanding Your Setup

Connecting Two DX15 Speakers to a Mixer

1. Take two XLR cables and connect the male ends to the Line Inputs on the speakers.
2. Plug the other ends into the Main Outputs of the mixer.
3. If your mixer uses ¼-inch outputs, you can use ¼-inch cables instead.
4. To test, connect a microphone to Channel 1 of the mixer.
5. Power on the mixer and speakers.
6. Adjust:
   • Line Level & Master Volume (on speakers)
   • Main Mix & Gain/Volume Knobs (on the mixer)
7. Check your mic—sound should be coming from both speakers.

Connecting Additional Speakers or Subwoofers

1. Use XLR cables to connect the Mix Output of your DX15 to the input of additional speakers or subwoofers.
2. Adjust the Line Level and Main Volume of the additional speakers.

LED Indicator for Clipping

The LED indicator on the back will warn you if the speaker is clipping (distorting due to excessive volume). Lower the volume on your speaker or mixer to prevent damage.

Conclusion

Setting up your Rockville DX15 Powered PA Speaker is straightforward and allows for multiple configurations. Whether you’re using it for a live performance, DJ setup, or PA system, this speaker provides powerful sound and easy expandability.