Introduction
The Rockville HC-55 Ceiling Speakers are perfect for adding clear, high-quality sound to any space, whether it's your home, office, or business. These speakers are designed to be installed in sheetrock or ceiling tiles, and the installation process is simple. Follow the steps below to easily install your HC-55 ceiling speakers.
What You’ll Need
- Rockville HC-55 Ceiling Speakers
- Paper cutout guide (included)
- Blade (not included) for cutting the ceiling tile
- Grille remover tool (included)
- Phillips screwdriver
- Wiring for connection to an amplifier or receiver
- Amplifier or receiver with 8-ohm support
Step-by-Step Instructions
1. Prepare the Ceiling Tile
- Take the included paper cutout guide and place it on your ceiling tile.
- Use a blade to cut along the guide, creating a hole for the speaker.
2. Remove the Speaker Grille
- Use the grille remover tool (included) to remove the grille from the speaker.
- Once removed, you'll see four Phillips screws on the speaker.
3. Place the Speaker
- Place the speaker through the hole you cut out in the ceiling tile.
- Tighten the four screws with a Phillips screwdriver to pull the speaker securely into place.
4. Wire the Speaker
- The speaker has red and black push terminals for easy wiring.
- Push the terminals to open them, insert the speaker wires, and release to hold the wires in place.
5. Install the Speaker in the Ceiling
- Once the speaker is wired, place the tile with the speaker in the ceiling.
- Ensure the speaker is securely mounted and connected to your amplifier or receiver.
6. Connect to Amplifier or Receiver
- Make sure to run the wire from your speaker to your amplifier or receiver.
- The HC-55 speakers are 8-ohm rated, so you can connect two speakers to each channel if your amplifier or receiver is 4-ohm stable.
Conclusion
Installing your Rockville HC-55 Ceiling Speakers is easy and quick, giving you great sound without taking up space.
Comments
0 comments
Article is closed for comments.