RM-PREMIUM-65: How To Install

Introduction

The Rockville RM Premium 65 speakers can be installed in different ways, including directly into your boat or within speaker pods such as wakeboard tower speakers or kick panel enclosures. This guide will walk you through the step-by-step installation process, including wiring, securing the speakers inside pods, and mounting them to your boat or vehicle.

What You’ll Need

Rockville RM Premium 65 Speakers
Compatible Speaker Pods (Wakeboard Tower/Kick Panel Pods, etc.)
Speaker Wire
Drill & Screws (included in mounting hardware)
Dust Blower (optional, for cleanup)

Step 1: Choosing the Right Pods

Before installing, ensure your pods are compatible with the RM Premium 65 speakers.

• The Rockville Rock ZRS 6.5” pods are a perfect fit.
• If using other pods, make sure they provide enough space for the speaker to fit securely.

Tip: The pod’s internal space should be large enough to house the speakers snugly.

Step 2: Preparing the Speaker Pods

1. Determine the hole placement for the speaker wire.
   • Look at the speaker’s terminal position (usually at the bottom).
   • Drill a small hole at the bottom of the pod for routing the speaker wire.
2. Feed the wire through the pod.
   • Insert the speaker wire through the hole at the bottom of the pod.
   • Pull through enough wire, leaving some slack for adjustments.

Step 3: Connecting the Speaker Wires

Each speaker has two terminals:

• Positive (+) – Usually marked with red.
• Negative (-) – Usually marked with black.

Connecting the Wires:

1. Match the wires correctly:
   • White wire → Positive (+) terminal
   • Black wire → Negative (-) terminal
2. Attach the spade terminals from the speaker wire onto the corresponding speaker terminals.
3. Double-check polarity:
   • Ensure correct connections to avoid phase issues.
   • For amplifier setup, match the white wire to the amp’s (+) terminal and the black wire to the (-) terminal.

Tip: Incorrect wiring can lead to poor sound quality or speaker damage.

Step 4: Securing the Speakers Inside the Pods

1. Align the speaker inside the pod.
   • Make sure the speaker logo is upright for a clean, professional look.
2. Ensure the wire is properly routed inside the pod.
3. Fasten the speaker using the included screws.
   • Insert screws into the pre-drilled mounting holes.
   • Use a drill or screwdriver to secure the speaker tightly.

Tip: Use a dust blower to remove debris while drilling.

4. Check for a secure fit.
   • Gently pull the speaker grill to test if it's firmly attached.
   • If secure, repeat the same process for the second speaker.

Step 5: Mounting the Speaker Pods

Once the speakers are inside the pods, it's time to mount them to your boat or vehicle.

1. Position the pods where you want them mounted.
2. Secure the pods using the included mounting hardware.
3. Ensure they are firmly attached to prevent vibrations or movement.

Tip: If installing wakeboard tower speakers, ensure they are securely clamped and angled properly for optimal sound projection.

Step 6: Connecting to an Amplifier

1. Run the speaker wires to your amplifier.
2. Connect each speaker’s wire to its corresponding channel:
   • Match white to (+) and black to (-) on the amp terminals.
3. Double-check all connections before powering on the system.

Tip: For best performance, use a marine-grade amplifier to drive the speakers in a boat setup.

Conclusion

By following these steps, you can successfully install your Rockville RM Premium 65 speakers into pods for boat, vehicle, or wakeboard tower use. This setup ensures great sound quality while keeping your installation clean and secure.

Key Takeaways:

Ensure pods are large enough for the speakers.
Properly route and connect the speaker wires.
Securely fasten speakers inside the pods.
Mount the pods properly for stability.
Connect the speakers to an amplifier for optimal performance.