RTP32 | RTP82: How To Set Up Adjustable Height Totem Stands

Introduction:

This guide will walk you through the easy setup process for your Rockville RTP Adjustable Height Totem Stand. While the demonstration uses the RTP32W (adjustable from 39" to 69"), these instructions also apply to the taller RTP82 model (adjustable from 4'2" to 8'2"). No technical experience is needed—just follow these simple steps and you’ll have your stand ready to go in minutes.

Requirements:

• RTP32W or RTP82 totem stand
• Hand fastening bolts and knobs (included)
• Optional: white scrim, 35mm speaker mounting pole, RockPAR 50 light, and intelligent moving head light (e.g. Intimidator Spot)

Step-by-Step Instructions:

1. Assemble the Vertical Beams

• Start by placing one of the vertical beams onto the base grooves.
• Align the beam so it sits securely in place.
• Repeat this for the second vertical beam on the opposite side.

2. Attach the Bottom Horizontal Support

• Take one horizontal beam and use it as the bottom bridge between the two vertical beams.
• Insert one of the hand fastening bolts into a corner hole and tighten it until secure.
• Repeat on the other side.

3. Secure the Top Plate

• Align the top plate with the grooves on the tops of the vertical beams.
• Insert a hand tightening bolt through each top corner and secure them.

4. Add the Speaker Mounting Pole (Optional)

• If you're using the stand for a PA speaker, install the 35mm mounting pole:
  • Insert a hand fastening knob into the hole at the top.
  • Tighten it securely to hold the pole in place.

5. Install the Scrim (Optional)

• Choose between black or white scrim (demonstrated with white).
• Drape the scrim over the top like a shirt and pull it down over the frame.
• Pull any slack to the bottom for a clean look.
• The scrim will stretch to fit all height settings.

6. Add Internal Lighting Effects (Optional)

• Place a RockPAR 50 or similar light inside the center of the totem.
• With the scrim on, this will create a glowing column of light—ideal for DJ booths or stage setups.

7. Enhance with Moving Head Lights (Optional)

• Mount an intelligent moving head like the Intimidator Spot to the top.
• When in sound-activated mode, it will respond to audio, turning your totem into a dynamic lighting effect.
• You can combine multiple lights for an even more engaging visual display.

Troubleshooting & FAQs:

Q: The totem seems unstable after setup. What should I check?

• Ensure all hand tightening bolts are fully secured.
• Make sure the vertical beams are properly aligned in the base grooves.

Q: How do I hide the wiring when using internal lights?

• Run the power cable along one of the inside corners and secure it with zip ties or tape before putting on the scrim.

Q: Can I use both the mounting pole and internal lighting at the same time?

• Yes, as long as the internal light fits within the column and doesn’t interfere with the speaker pole’s placement.

Conclusion:

Setting up your Rockville RTP32W or RTP82 Totem Stand is quick and flexible. Whether you're using it for speakers, lights, or a creative light column, this stand is built for versatility and ease of use.