RCS52: How To Set Up Lighting Stand Cross Bar

Introduction

The Rockville RCS52 Lighting Crossbar is a versatile mounting solution that allows you to attach up to six lights on any 35mm speaker stand. This guide will walk you through the assembly, expansion, and light mounting process, making it easy to set up your lighting rig for DJ events, stage performances, or parties.

What You Need

• Rockville RCS52 Lighting Crossbar
• Lights with mounting brackets
• Rockville RVSS 4A Speaker Stand (or any 35mm speaker stand)
• Screws, knobs, and washers (included with the crossbar)

Step-by-Step Instructions

1. Expanding the Crossbar for Additional Lights

The RCS52 crossbar can expand to accommodate more lights. Follow these steps to extend it:

1. Remove the screws, washers, and knobs from each side of the crossbar.
2. Pull each end outward until you see the second hole align with the outer bar hole.
3. Reinsert the screws into the new holes to secure the expanded sections.
4. Use additional screws, washers, and knobs to attach extra lights to the expanded wings.

2. Mounting the Crossbar on a Speaker Stand

1. Loosen the knob on the bottom of the crossbar.
2. Slide the pole mount onto the top of your 35mm speaker stand.
3. Tighten the knob securely to lock the crossbar in place.

3. Attaching Lights to the Crossbar

1. Identify the pre-installed screws on the crossbar. Each screw has:
   • A main screw running through the crossbar.
   • A knob and washer underneath for securing lights.
2. Loosen the knob and remove the washer, setting them aside.
3. Prepare the light for mounting:
   • Ensure the light has a mounting bracket attached.
4. Attach the light to the crossbar:
   • Place the washer on top of the light’s mounting bracket.
   • Align the bracket hole with the screw on the crossbar.
   • Insert the screw through the washer and mounting bracket.
   • Tighten the knob underneath to secure the light.
5. Repeat for additional lights, following the same process.

4. Adjusting and Powering the Lights

• Once all lights are attached, power them on and set them to the desired mode or color.
• If using the RVSS 4A speaker stand, you can adjust the height for the best lighting coverage.

5. Adding Fog Machines or Additional Gear

• The same steps can be followed to attach fog or haze machines to the crossbar.
• Mix and match different types of lights for a custom lighting setup.

Conclusion

Setting up your Rockville RCS52 Lighting Crossbar is quick and easy, whether you're using it for DJ setups, stage lighting, or event production. With expandable wings and multiple mounting points, you can customize your lighting rig to fit any event.