DX12: How To Set Up w/ A Mixer

Introduction:
Setting up a mixer with your Rockville DX12 powered speakers gives you more control over the sound and more options when plugging in microphones, instruments, and other audio sources. This guide will walk you through the steps to connect your mixer to the DX12 speakers, using either XLR or 1/4-inch cables, to get your system up and running.

Requirements:

• Rockville DX12 powered speakers
• Rock Mix 10FX or any other mixer
• 2 XLR cables (or 1/4-inch cables if your mixer has 1/4-inch outputs)

Step-by-Step Instructions:

1. Connect the Mixer to the Speakers

• Using XLR Cables:
  • Plug the female ends of the two XLR cables into the main mix outputs on your mixer.
  • Plug the other ends of the cables into the line inputs on the back of each DX12 speaker.
• Using 1/4-Inch Cables:
  • If your mixer has 1/4-inch outputs, use 1/4-inch cables and plug them into the same line input on the speakers.

2. Adjust the Volume on the Speakers

• Raise the line volume knobs on both DX12 speakers to an appropriate level.
• Also, adjust the master volume knob to ensure you can hear everything coming through the speakers.

3. Set Up the Mixer

• On your mixer, raise the main mix knob to ensure the sound from the connected sources (microphones, instruments, etc.) comes through both speakers.

4. Test the Setup

• For a quick test, connect your phone to the mixer via Bluetooth.
• Play some music from your phone to ensure the sound is coming out of both speakers.

5. Fine-Tune the Sound

• If needed, adjust the volume on your phone and speakers to balance the sound to your liking.

Conclusion:

Setting up your mixer with the Rockville DX12 powered speakers is easy and allows you to take full control of your audio sources. Whether you’re using XLR or 1/4-inch cables, the DX12 speakers provide versatile options to get the perfect sound.