ACC-EX: How To Set Up & Use

Introduction: In this guide, we'll walk you through the simple process of setting up your ACC-EX speaker stand extension. Whether you're looking to raise the height of your speaker for a gig or event, or you need to extend your lighting rig, this extension is an easy-to-use accessory. Let’s get started!

Step-by-Step Instructions:

1. Preparing the ACC-EX Extension

• Unbox the ACC-EX Extension: You’ll find the extension, along with the height adjustment knob.

2. Attaching the Extension to the Speaker Stand

• Loosen the Knob: Start by loosening the knob on the extension all the way.
• Align the Holes: Line up the hole at the bottom of the extension with the top of your speaker stand.
• Insert the Extension: Place the extension onto the speaker stand, pushing it down until it can’t go any further.
• Tighten the Knob: Once the extension is in place, tighten the knob to secure it firmly onto the stand.

3. Raising the Height

• Maximize the Height: The extension can increase your speaker’s height even further. If needed, loosen your existing speaker stand and raise it to the desired height.
• Place Your Speaker: After the extension is set up, you can place your speaker on top.

4. Using the ACC-EX Extension for Lighting Rigs

• The ACC-EX extension is also great for lighting rigs, such as the RCS 52 lighting tree. Simply follow the same steps to set up the extension on the lighting stand.

5. Breaking Down the Setup

• Removing the Extension: When you're done, simply loosen the knob on the front of the extension.
• Pull Off the Extension: Carefully pull the extension off the stand.
• Tighten the Knob: If you’re not using the extension again immediately, tighten the knob back up to prepare for future use.

Conclusion:

The ACC-EX extension is a quick and easy way to add extra height to your speaker stand or lighting rig. Whether you’re performing at a gig or need to adjust your setup for better visibility, this extension provides flexibility and ease of use.