ROGAN STAND: How To Set Up A Microphone

Introduction

The Rockville Rogan Stand Pro Boom Arm is a professional microphone stand that works with both dynamic and condenser microphones. This guide will walk you through how to set up each type of microphone, manage cables for a clean setup, and attach a pop filter for optimal audio quality.

Setting Up a Dynamic Microphone

Step 1: Attach the Mic Clip

• Take the included mic clip and screw it onto the thread at the top of the boom arm.
• Slide your dynamic microphone into the mic clip.

Step 2: Connect the Microphone Cable

• Use the included XLR cable:
  • Plug the female end into your microphone.
  • Run the cable through the built-in cable grooves in the stand:
    1. Open the cable clamps on the top and bottom arms.
    2. Place the cable inside the grooves.
    3. Close the clamps to secure the cable.
• Plug the other end of the cable into your audio interface.

Step 3: Adjust the Stand & Mic Position

• Use the knobs on the stand to adjust height and angle.
• Adjust the mic angle using the small knob near the clip.
• If needed, use the included mic clip adapter to attach different mic clips.

Setting Up a Condenser Microphone

Step 1: Attach the Shock Mount

• If your shock mount requires an adapter, screw the mic clip adapter onto the boom arm’s threading.
• Secure the shock mount onto the boom arm.
• Pinch the shock mount sides and insert the condenser microphone.

Step 2: Position the Microphone

• Condenser microphones can be:
  • Facing upright
  • Upside down, depending on your setup.

Step 3: Connect & Route the Mic Cable

• Plug the XLR cable into the microphone.
• Run the cable through the grooves using the same process as before.
• Plug the other end of the cable into your audio interface.

Step 4: Attach a Pop Filter (Optional)

A pop filter helps eliminate popping sounds (plosives) for clearer recordings.

• Loosen the clamp knob on the pop filter.
• Attach the clamp to the boom arm, ensuring the hook sits in the groove.
• Tighten the clamp to secure the filter.
• Position the filter in front of the microphone.

Conclusion

The Rockville Rogan Stand Pro Boom Arm makes it easy to set up both dynamic and condenser microphones with clean cable management and adjustable positioning.

Key Takeaways:

✅ Secure the microphone clip or shock mount properly.
✅ Run cables through the built-in grooves for a clean look.
✅ Use a pop filter with condenser microphones for better sound.