RVMIC3 V2: How To Set Up & Use

Introduction

In this guide, we'll walk you through the steps to set up your Rockville RVMic3 V2, including adjusting the mic stand, attaching your dynamic or condenser microphone, and incorporating additional features like the shock mount, pop filter, and ISO box. Follow these simple steps to enhance your home studio setup.

Step-by-Step Instructions

Step 1: Set Up the Stand Legs

1. Adjust the Legs:
   • When you first receive your stand, the legs may be raised. Loosen the knob on the stand and guide the legs all the way down until they can't go further. Then, tighten the knob to lock them in place.
2. Raise the Legs:
   • Pull the legs of the stand all the way up. If you find a clip on one of the legs, remove it.
3. Position the Stand:
   • Place the stand flat on the floor once the legs are adjusted.

Step 2: Adjust the Height of the Stand

1. Use the Quick Release Hand Clutch:
   • Press down on the clutch and adjust the height. Release the clutch to lock the height in place once you've reached your desired position.

Step 3: Adjust the Boom Arm

1. Position the Boom Arm:
   • Loosen the knob on the boom arm to adjust its angle. Once in place, tighten the knob to lock it.
2. Tighten the Boom Arm:
   • If the boom arm sways too much, use the grip and tighten it to the left to prevent movement.
3. Adjust the Reach:
   • Use the two knobs to adjust the reach of the boom arm. Loosen the knobs, extend the arm, and tighten them once the desired reach is set.

Step 4: Attach the Mic Clip

1. Mount the Mic Clip:
   • Take the included mic clip and screw it onto the top of the stand. You can adjust the clip to either a 3/8" or 5/8" threading, depending on your microphone type.

Step 5: Attach Your Dynamic Microphone

1. Insert the Microphone:
   • Slide your dynamic microphone into the mic clip and secure it in place.
2. Organize the Cable:
   • Use the wire management clips to run the XLR cable neatly along the stand.

Step 6: Set Up a Condenser Microphone (Optional)

1. Attach the Shock Mount:
   • Screw the shock mount onto the stand using the threading, adjusting it as needed.
2. Mount the Condenser Mic:
   • Place the condenser microphone into the shock mount.
3. Add a Pop Filter:
   • Attach the pop filter by loosening the clamp and securing it on the stand. Adjust it in front of the microphone to reduce plosive sounds (like P's and T's).

Step 7: Set Up Your Smartphone or Tablet (Optional)

1. Attach the Holder:
   • Line up the threading of your smartphone/tablet holder with the top of the stand and screw it on.
2. Mount the Smartphone/Tablet:
   • Secure your device in the holder for easy access to lyrics, notes, or other content during recordings.

Step 8: Attach an ISO Box (Optional)

1. Remove the Boom Arm:
   • Loosen and remove the boom arm to reveal the 3/8" threading.
2. Mount the ISO Box:
   • Attach the ISO box using the provided attachment piece. Screw it into the 3/8" threading on the stand.
3. Adjust the ISO Box:
   • Use the quick release clutch to adjust the height of the ISO box, making it easier to raise or lower as needed.

Conclusion

Setting up your Rockville RVMic3 V2 is a straightforward process that allows you to customize your recording setup with ease. By following the steps above, you can securely attach your microphone, manage cables, and optimize your home studio environment.