RWM1203VS: How To Set Up & Use

Introduction

The Rockville RWM1203VS is a VHF wireless dual headset microphone system designed for live performances, DJ events, houses of worship, and more. This guide will walk you through the setup process step by step so you can start using your system with minimal effort.

What's Included

• Two-channel wireless receiver
• Two wireless headset microphones
• Two body packs
• Two 9V batteries for the body packs
• ¼-inch cable
• Screwdriver (for adjusting volume on the body packs)

Step-by-Step Setup Guide

1. Powering the Receiver

1. Take the attached power cable from the receiver.
2. Plug it into a power outlet.
3. Turn on the receiver.

2. Setting Up the Wireless Headsets

1. Take one of the body packs and push up on the front to reveal the battery compartment.
2. Insert one of the included 9V batteries into the compartment.
3. Close the battery compartment.
4. Take one of the headsets and connect the male end to the body pack input.
5. Screw the threaded connector to lock it in place.

3. Connecting to a Powered Speaker

1. Take the included ¼-inch cable.
2. Plug one end into the Audio Out (¼-inch output) on the back of the receiver.
3. Plug the other end into the ¼-inch input on your powered speaker.
4. Raise the antennas on the receiver for better range.
5. Turn on the receiver.
6. Set the body pack switch to ON and put on the headset.
7. Raise the volume on channel 1 of the receiver.
8. You should now hear your voice coming through the speaker.

4. Understanding Frequency Channels

• Each body pack is assigned a specific channel.
• The back of the receiver lists two frequencies:
  • Lower frequency → Channel 1
  • Higher frequency → Channel 2
• Check the bottom of each body pack to see which frequency it corresponds to.

5. Adjusting Microphone Sensitivity

• Use the included screwdriver to adjust the sensitivity knob on the body pack.
• This controls how much volume the microphone picks up.

6. Muting the Microphone

• Flip the switch on the body pack to the middle position to mute the microphone.

7. Using with a Mixer and Passive Speakers

If you're using a mixer and passive speakers, follow these steps:

1. Take the ¼-inch cable and plug it into the Audio Out (¼-inch output) on the receiver.
2. Plug the other end into a ¼-inch input on the mixer.
3. Turn on the mixer.
4. Turn on the receiver.
5. Put on the headset and set the body pack switch to ON.
6. On the mixer, adjust:
   • Channel fader (raise the volume on the channel you’re using).
   • Gain knob (adjust input sensitivity).
   • Main left and right faders (control overall output).
   • Channel volume on the receiver.
7. Your voice should now be coming through the passive speakers.

Additional Features

• Auto-pairing: Each microphone automatically connects to its designated frequency.
• Belt clip: The body pack includes a belt clip for hands-free movement.
• Mixer integration: You can use the mixer's EQ and effects to further customize your sound.

Conclusion

The Rockville RWM1203VS is easy to set up and use, making it an excellent choice for hands-free performances, speeches, and events. With its dual headset design, automatic pairing, and mixer compatibility, it provides professional-quality sound without complicated configurations.