RVSS2 WHITE: How To Set Up & Use

Introduction

This article guides you through the simple setup process for your Rockville RVSS2 White Speaker Stands. Following these easy steps, you'll be ready for your next event, rehearsal, or gig in no time. No technical experience is required.

Requirements:

• Rockville RVSS2 Speaker Stands (White)
• Speakers with a 35mm pole mount
• Optional: Mixer, cables, and accessories like the RCS52 lighting crossbar.

Step-by-Step Instructions

Setting Up the Stands

Step 1: Adjust the Legs

1. Locate the bottom knob at the base of the stand.
2. Loosen the knob by turning it counterclockwise.
3. Push down gently on the stand's base to spread the legs.
4. Tighten the knob to secure the legs in place.

Step 2: Adjust the Height

1. Loosen the top knob on the stand.
2. The pole will pop up automatically due to the internal spring.
3. Adjust the pole to your desired height.
4. Insert the safety pin into the lowest hole visible at your chosen height.
5. Tighten the top knob securely to lock the height in place.

Mounting Your Speakers

• Ensure your speakers have a 35mm pole mount.
• Check under your speaker for a locking knob. If present:
  • Loosen the locking knob before placing the speaker onto the stand.
  • Align the speaker’s pole mount onto the stand’s top pole.
  • Tighten the locking knob to secure the speaker firmly.
• Repeat for your second speaker.

Optional: Attaching the RCS52 Lighting Crossbar

• Loosen the knob on the side of the crossbar.
• Align and attach the pole mount of the crossbar onto the stand.
• Tighten the knob on the crossbar securely.
• Attach lights to the crossbar for a complete setup.

Breaking Down the Stands

Follow these steps in reverse order:

1. Remove your speakers and accessories.
2. Loosen the top knob, remove the safety pin, and push the top section down.
3. While pushing down, tighten the top knob to lock the pole in place.
4. Loosen the bottom knob and pull the base up to collapse the legs.
5. Once fully collapsed, tighten the bottom knob to lock the legs.

Packing the Stands into the Carry Bag

1. Open your carry bag, noting the divider inside for individual stands.
2. Each pocket has velcro straps:
   • The longer velcro strips are for securing the legs.
   • The shorter velcro strips secure the top pole.
3. Place the legs where the longer velcro strips are, and the top pole where the shorter strips are.
4. Secure both sides of each stand tightly with the velcro strips.
5. Close the carry bag securely for safe and easy transportation.

Troubleshooting & FAQs

Q: My stand isn’t extending upwards after loosening the knob.

• A: The internal spring may be stuck. Manually lift the pole gently to engage the spring mechanism.

Q: My speaker wobbles on the stand.

• A: Ensure you tightened the locking knob beneath the speaker firmly. Double-check the alignment of the speaker’s pole mount with the stand.

Q: The legs won’t fold easily when packing up.

• A: Loosen the bottom knob sufficiently and pull up gently on the base of the stand. Then tighten again to lock it in place.

Conclusion

You've successfully learned how to easily set up and break down your Rockville RVSS2 White Speaker Stands.