HC655-16: How To Set Up In-Ceiling Home Theater Speakers

Introduction

This guide will walk you through the simple process of installing your Rockville HC655-16 in-ceiling speakers. These speakers are designed for easy installation in both sheet rock and ceiling tiles. No advanced tools or technical expertise are required.

Requirements:

• HC655-16 speakers (included)
• Paper cutout guide (included)
• Grill remover tool (included)
• Phillips screwdriver
• Blade/utility knife
• Speaker wire
• Compatible amplifier or receiver

Step-by-Step Instructions

1. Prepare the Ceiling

1. Use the included paper cutout guide and place it on the ceiling where you want the speaker installed.
2. With a blade or utility knife, cut out the hole by following the guide.

2. Remove the Speaker Grill

1. Take the grill remover tool included with your speakers.
2. Gently remove the grill from the front of the speaker.

3. Position the Speaker

1. With the grill removed, locate the four Phillips screws on the speaker.
2. Insert the speaker into the hole you cut.
3. Tighten the four screws evenly. This will pull the speaker into place and secure it to the ceiling.

4. Connect the Wiring

1. Locate the black and red push terminals on the back of the speaker.
2. Insert your speaker wire by pressing the terminals:
   • Black terminal = negative (-)
   • Red terminal = positive (+)
3. Double-check that your polarity matches correctly to avoid sound issues.

5. Connect to Your Amplifier/Receiver

1. Run the connected speaker wires to your amplifier or receiver.
2. Remember: these are 16-ohm speakers.
   • If your amplifier is 4-ohm stable, you can safely run up to four HC655-16 speakers per channel.

6. Replace the Grill

1. Once the wiring and placement are complete, snap the grill back onto the speaker for a clean, flush look.

Troubleshooting & FAQs

Q: My speaker doesn’t produce sound after installation. What should I check?

• Ensure the amplifier or receiver is powered on.
• Double-check that the speaker wire polarity is correct (red to red, black to black).
• Verify that the wire is fully inserted into the push terminals.

Q: Can I install these speakers in both sheet rock and ceiling tiles?

• Yes, the installation process is the same for both materials.

Q: How many speakers can I run on my amplifier?

• Since the HC655-16 is a 16-ohm speaker, you can run four speakers per channel on a 4-ohm stable amplifier.

Conclusion

Installing your Rockville HC655-16 in-ceiling speakers is quick and straightforward. By using the included cutout guide, securing the speaker with the built-in clamps, and properly wiring to your amplifier, you can enjoy high-quality audio in your home setup.