TITAN MIX12C: How To Assemble and Pack

Introduction:

This article will guide you through the simple process of assembling and packing your Rockville TITAN MIX12C system. Whether you're setting up for a performance or event, this step-by-step tutorial will help you get your system up and running in no time. No technical experience is required, and we’ll cover all the steps, including setting up the speaker, subwoofer, and connecting the power. If you need to disassemble it later, we've also included instructions on packing the system back up.

Requirements:

• Rockville TITAN MIX12C

Step-by-Step Instructions:

Step A: Unbox the System

Start by carefully removing and laying out (for easy access) all the components from the packaging:

• Array Speaker & Travel Bag
• Long 29" Spacer Pole (used to elevate the Array Speaker to 82" total height)
• Short 12" Spacer Pole (used to lower the Array Speaker to 65" total height)
• Subwoofer & Travel Cover
• 8-Foot PowerCon Cable

Step B: Assemble the Subwoofer and Pole

1. Take the Spacer Pole and align one of its ends with the port on top of the subwoofer.
2. Ensure that the silver circle on the pole is facing the front of the subwoofer.
3. Insert the pole into the port on the top of the subwoofer until it’s secure.

Step C: Attach the Array Speaker

1. Align the port on the bottom of the array speaker with the connector on top of the pole.
2. Slide the Array Speaker down onto the connector until it’s fully seated and connected.

Step D: Connect the Power Cable

1. Take the blue end of the PowerCon cable and insert it into the PowerCon port located on the back of the subwoofer.
2. Ensure that the grooves on the PowerCon cable line up with the grooves inside the port.
3. Twist the cable to the right until it clicks into place.
4. Plug the other end of the PowerCon cable into a power source.

Step E: Adjust the Height (Optional)

If you prefer a lower array setup:

1. Replace the Long Spacer Pole with the Short Spacer Pole.
2. Ensure the silver circle on the new pole is facing the front.
3. Insert one end of the pole into the subwoofer's top port.
4. Attach the Array Speaker to the Short Spacer Pole by lining up and pushing it onto the connector.

Your TITAN MIX12C is now fully assembled and ready for use!

Troubleshooting & FAQs:

• Q: The PowerCon cable doesn’t seem to connect properly. What should I do?
  • A: Ensure the grooves on the cable align properly with the grooves inside the PowerCon port. Once aligned, twist the cable to the right until it clicks into place.
• Q: Can I adjust the height of the array speaker?
  • A: Yes, the system comes with a smaller spacer pole if you'd like the array to be lower. Follow the same assembly steps as with the standard pole, ensuring the silver circle is facing the front.
• Q: How do I pack the system away?
  • A: Simply reverse the steps of assembly. Disconnect the power con cable, remove the array speaker from the pole, and remove the pole from the subwoofer. Then pack all components back into the bag.

Conclusion:

You have now successfully assembled your Rockville TITAN MIX12C system! By following these simple steps, you can quickly set up and start using your system for any event. If you need to pack it away, just follow the steps in reverse.