HC85 LED: How to Install Rockville In-Ceiling Speakers

Introduction

This article will guide you through the simple process of installing your Rockville HC85 LED In-Ceiling Speakers. These speakers can be installed in either sheetrock or ceiling tiles, and the installation steps are identical for both surfaces. Whether you're a beginner or experienced with audio equipment, this guide makes the process easy to follow.

Requirements:

• Rockville HC85 LED In-Ceiling Speakers
• Included paper cutout guide
• Blade or utility knife
• Standard Phillips screwdriver
• Speaker wire
• Compatible amplifier or receiver (4-ohm or 8-ohm compatible)

Step-by-Step Instructions

1. Prepare Your Ceiling

• Use the included paper cutout guide to mark the spot where the speaker will be installed.
• Lay the guide flat on your ceiling tile or sheetrock.
• Carefully cut out the hole by following the outline using a blade or utility knife.

2. Remove the Speaker Grill

• Locate the grill remover tool provided with your speakers.
• Insert the tool to lift and remove the grill from the front of the speaker.

3. Insert and Secure the Speaker

• Once the grill is removed, you’ll reveal four Phillips screws on the speaker.
• Place the speaker into the cut-out hole.
• Use a Phillips screwdriver to tighten the screws. This will secure the speaker by pulling it snugly into the ceiling from behind.

4. Connect Speaker Wires

• Locate the black and red push terminals on the rear of the speaker.
• Insert your speaker wires:
  • Red wire into the red terminal
  • Black wire into the black terminal
• Push down the terminals, insert the bare wire ends, and release to lock them in place.

5. Install the Tile and Connect to Amplifier

• Position the ceiling tile with the mounted speaker back into the ceiling.
• Run the connected speaker wire to your amplifier or receiver.
• Note: These speakers are 8 ohms, so if you're using a 4-ohm stable amp, you may connect two speakers per channel.

6. Activate the LED Feature

• The LED lighting feature does not require any additional setup.
• LEDs automatically respond to the sound or music playing through the speaker.
• The brightness of the LEDs increases with the volume level of the audio source.

Troubleshooting & FAQs

Q: Do I need a special power source for the LEDs?

• No, the LEDs are powered directly through the speaker and respond to audio input.

Q: Why are the LEDs dim?

• The LEDs brighten with higher audio volume. A low volume may result in dim lighting.

Q: Can I install these speakers in materials other than ceiling tiles or sheetrock?

• These speakers are designed for tile and sheetrock mounting only.

Q: How many HC85 speakers can I connect to my amp?

• Each speaker is 8 ohms. If your amplifier is rated for 4 ohms per channel, you can safely run two speakers per channel.

Conclusion

With just basic tools and the included accessories, installing your Rockville HC85 LED In-Ceiling Speakers is quick and hassle-free. The speakers hook up easily to your existing audio system and add a dynamic LED visual effect that responds to sound.