How To Use the Primary Secondary Function on the Rockville Stage Panel 336

Introduction:

This article explains how to use the primary secondary function (formerly known as master/slave mode) on your Rockville Stage Panel 336 lighting system. This feature allows you to control multiple lights in sync without needing a DMX controller. The process is straightforward and suitable for users of all experience levels. You will need your Stage Panel 336 lights and DMX cables.

Step-by-Step Instructions

1. Selecting the Primary Light
   • Decide which light will act as the primary (main) unit. This light will control all others in the chain.
2. Connecting the Lights
   • Take a DMX cable and plug the male end into the DMX Out port on the primary light.
   • Plug the other end of the cable into the DMX In port on the second light.
   • To add more lights, repeat this process:
     • Connect a DMX cable from the DMX Out of the previous light to the DMX In of the next light in the chain.
3. Setting the DMX Address
   • On each light, press the Menu button until you reach the DMX address display.
   • Set all lights in the chain to the same DMX address (for example, 001).
4. Syncing Modes and Colors
   • Once all lights are connected and set to the same DMX address, set the desired mode or color on the primary light.
   • All other connected lights will automatically follow the primary light’s settings.

Troubleshooting & FAQs

Q: The secondary lights are not following the primary light. What should I check?

• Ensure all DMX cables are securely connected from DMX Out to DMX In between each light.
• Confirm that all lights are set to the same DMX address.
• Make sure the primary light is set to the desired mode or color.

Q: Can I add more than two lights?

• Yes, you can connect as many Stage Panel 336 lights as needed by daisy-chaining DMX cables from one to the next.

Q: Do I need a DMX controller for this setup?

• No, the primary secondary function allows you to sync multiple lights without a DMX controller.

Conclusion

Using the primary secondary function on your Rockville Stage Panel 336 is a simple way to control multiple lights together. Just connect your lights with DMX cables, set the same DMX address on each, and control all units from the primary light.