STAGE PANEL 336: Controls, Inputs & Outputs

Introduction:

This article provides a clear overview of the controls, inputs, and outputs for the Rockville Stage Panel 336 lighting system. It is designed for users of all experience levels and will guide you through the different modes and settings available on your light. No technical background is required. All you need is your Stage Panel 336 unit.

Step-by-Step Instructions

1. Locating the Controls and Display
   • On the back of the light, you will find:
     • A display screen showing the current mode.
     • Control buttons located below the display.
2. Using the Control Buttons
   • Menu Button: Cycle through the different modes.
   • Up and Down Buttons: Adjust settings within each mode.
   • Enter Button: Confirm and save your selections.
   • Tip: Hold down the Enter button to display the temperature of the light.
3. DMX Ports
   • Below the control buttons are the DMX In and DMX Out ports.
   • These ports are used for:
     • Connecting the light to a DMX controller.
     • Linking multiple Stage Panel 336 units using the primary/secondary function.
4. Operating Modes
5. 4.1. DMX Address Mode
   • Assign a DMX address to the light for use with a DMX controller or when linking multiple lights.
   • Use the Up/Down buttons to select the address, then press Enter to save.
6. 4.2. DMX Channel Mode
   • Choose how much control you want over the light via your DMX controller.
   • Available channel modes: 4, 6, 12, 24, and 30.
   • Select your preferred mode and press Enter to confirm.
7. 4.3. Custom Color Mixing
   • Set a custom color using the Red, Green, and Blue menus.
   • Adjust each color’s intensity with the Up/Down buttons.
   • After setting each color, press Menu to move to the next color.
8. 4.4. Strobe Bar Menu
   • Adjust the intensity of the strobe bar effect that appears with your custom color.
   • Higher values increase the visibility of the strobe bar.
9. 4.5. Strobe Menu
   • Add a strobe effect to your custom color.
   • Increase the value for a faster strobe.
10. 4.6. Auto Preset Mode
    • Select from 10 preset lighting effects.
    • Use the Up/Down buttons to cycle through the presets.
11. 4.7. Custom Effect Mode
    • Create your own effect using two submenus:
      • EF: Controls RGB effects.
      • UF: Controls strobe effects.
    • Adjust the effect type and speed as desired.
12. 4.8. Sound Mode
    • The light reacts to music or sound via the built-in microphone.
    • 10 sound modes are available.
    • Use the Up/Down buttons to select a mode.
    • Adjust the microphone sensitivity (1–15) to control how easily the light responds to sound.
      • Higher sensitivity reacts to quieter sounds.
      • Lower sensitivity reacts only to louder sounds.

Troubleshooting & FAQs

Q: The light does not respond to my DMX controller. What should I check?

• Ensure DMX cables are properly connected.
• Confirm that the DMX address and channel mode are set correctly.

Q: The sound mode is not reacting to music or sound.

• Check the microphone sensitivity setting and increase it if needed.
• Make sure the built-in microphone is not blocked.

Q: How do I save my settings?

• Press the Enter button after making your selection in any mode.

Q: Can I link multiple lights together?

• Yes, use the DMX In and Out ports and set all lights to the same DMX address and channel mode.

Conclusion

With these instructions, you should have a clear understanding of the controls, inputs, and outputs of your Rockville Stage Panel 336. For a visual demonstration, refer to the accompanying video or explore additional resources such as the instruction manual or community forums.