RWM-200 H2: How To Set Up The Receiver

Introduction:

This article will guide you through the process of setting up the receiver for your Rockville RWM-200 H2 wireless microphone system. The steps are simple and easy to follow, even if you have no technical experience. By the end of this guide, you’ll have your receiver powered up and ready to use.

Requirements:

• Rockville RWM-200 H2 receiver
• Included power supply/adapter
• Two included antennas
• Access to a power outlet

Step-by-Step Instructions

1. Connect the Power Supply
   • Locate the included power adapter.
   • Plug the adapter end into the power port on the back of the receiver.
   • Plug the other end of the adapter into a power outlet.
2. Attach the Antennas
   • Find the two antenna ports on the back of the receiver.
   • Take each antenna and line up the grooves on the antenna with the grooves on the port.
   • Insert the antenna into the port.
   • Turn the base of the antenna to the right until you feel a click, locking it into place.
   • Repeat for the second antenna.
   • Adjust the antennas so they are upright and positioned as desired.
3. Power On the Receiver
   • After connecting the power and antennas, turn on the receiver using the power switch.

Troubleshooting & FAQs

Q: The antennas don’t seem to fit or lock in place. What should I do?

A: Make sure the grooves on the antenna and the port are properly aligned before turning the base to lock it in.

Q: The receiver does not power on.

A: Double-check that the power adapter is securely connected to both the receiver and the power outlet.

Q: Do I need any tools for setup?

A: No tools are required. All parts are included and designed for hand assembly.

Conclusion

Setting up the receiver for your Rockville RWM-200 H2 wireless microphone system is quick and straightforward. Once the receiver is powered and the antennas are attached, you’re ready to proceed with connecting microphones and other audio equipment.