RWM-200 H2: How To Reset & Change Frequencies

Introduction:

This article explains how to reset and change the frequencies on your Rockville RWM-200 H2  wireless microphone system. These steps are designed to be simple and easy to follow, even if you have no technical experience. Adjusting the frequencies can help resolve issues like audio dropouts or interference.

Requirements:

• Rockville RWM-200 H2  receiver
• Handheld microphones that came with the system

Step-by-Step Instructions

1. Understanding Frequency Controls
   • Each channel (A and B) on the receiver has its own frequency control buttons and a scan button.
   • You can manually select a frequency or use the scan feature to find the clearest frequency.
2. Manually Changing Frequencies
   • Locate the frequency control buttons for Channel A and Channel B on the receiver.
   • Press the frequency button to cycle through available frequencies for each channel.
3. Using the Scan Feature to Find the Clearest Frequency
   • For Channel A:
     • Hold down the scan button for Channel A.
     • The channel will begin scanning for the clearest frequency.
     • Once scanning is complete, a new frequency will appear on the display.
   • For Channel B:
     • Repeat the same process by holding down the scan button for Channel B.
4. Syncing the Microphone to the New Frequency
   • After setting a new frequency on the receiver, you need to sync the microphone:
     • Press the set (or sync) button on the receiver for the desired channel.
     • Immediately hold the corresponding microphone up to the IR sensor on the receiver.
     • The microphone will display the new frequency, confirming the sync.
   • Repeat for the second microphone if needed.

Troubleshooting & FAQs

Q: Why am I experiencing audio dropouts?

A: Audio dropouts can occur due to interference. Use the scan feature to find and set the clearest frequency for each channel, then sync your microphones.

Q: The microphone is not syncing to the new frequency. What should I do?

A: Ensure you are holding the microphone close to the IR sensor on the receiver immediately after pressing the sync button. Try again if the frequency does not update.

Q: Can I manually select a frequency instead of scanning?

A: Yes, use the frequency control buttons on each channel to manually select a frequency.

Q: Do I need to sync both microphones after changing frequencies?

A: Yes, each microphone must be synced to its respective channel’s new frequency.

Conclusion

Changing and resetting frequencies on your Rockville RWM-200 H2  wireless microphone system is quick and straightforward. This process helps maintain clear audio and prevents dropouts.