RWM-200 H2: How To Use w/ A Mixer

Introduction:

This article will guide you through connecting your Rockville RWM-200 H2  wireless microphone system to a mixer, ideal for larger productions such as live performances. The instructions are simple and easy to follow, even for users with no technical background. Before you begin, make sure you have the necessary cables and your audio equipment ready.

Requirements:

• Rockville RWM-200 H2  receiver and microphones
• Audio mixer
• Two XLR cables (for independent channel control) or one quarter-inch cable (for summed output)
• Powered speakers

Step-by-Step Instructions

1. Choose Your Output Method
   • The receiver has two types of outputs:
     • Quarter-inch mix output: Sends a combined signal from both microphones to a single mixer channel.
     • XLR outputs (Channel A and Channel B): Allows independent control of each microphone on separate mixer channels.
2. Connecting the Receiver to the Mixer Using XLR Outputs
   • For independent control, use two XLR cables.
   • Plug the female ends of the XLR cables into the XLR outputs on the back of the receiver (one for Channel A, one for Channel B).
   • Plug the male ends of the XLR cables into two separate channels on your mixer.
   • Keep track of which receiver output connects to which mixer input (e.g., Channel A to Mixer Channel 1, Channel B to Mixer Channel 2).
3. Power On and Set Up Your Equipment
   • Ensure your speakers and mixer are powered on.
   • Raise the gain knob for each mixer channel connected to the microphones.
   • Adjust the level knob for each channel as needed.
   • Raise the main mix knob on the mixer to send audio to the speakers.
   • Set the volume on your speakers to an appropriate level.
4. Adjust Receiver and Microphone Volume
   • On the receiver, set the volume knobs for each channel.
   • On each microphone, remove the end cap to access the volume control.
   • Set the microphone volume between 3 and 5 to avoid clipping or distortion.
5. Test the Microphones
   • Speak into each microphone and confirm that the sound is clear through the speakers.
   • Adjust mixer settings as needed for EQ and effects.
6. Take Advantage of Mixer Features
   • Use your mixer’s built-in EQ and effects to enhance the microphone sound as desired.

Troubleshooting & FAQs

Q: Why is there no sound from the microphones?

A: Check all cable connections, ensure the mixer and speakers are powered on, and verify that the gain and level knobs are raised.

Q: The sound is distorted or clipping. What should I do?

A: Lower the microphone volume (set between 3 and 5) and adjust the receiver and mixer levels.

Q: Can I use just one cable for both microphones?

A: Yes, use the quarter-inch mix output to send a combined signal to a single mixer channel, but you will not have independent control over each microphone.

Q: How do I use mixer effects with the microphones?

A: Connect each microphone to a separate mixer channel using XLR outputs, then apply EQ or effects as desired on your mixer.

Conclusion

Connecting your Rockville RWM-200 H2  wireless microphone system to a mixer is straightforward and allows you to take full advantage of your mixer’s features for live performances or events.