Skip to main content

RMH200 Owner's Manual

Keith Harris
Updated

Single-Din Marine Radio/Receiver Waterproof Gimbal Housing

 

Shaft Style Dual Knob Radio/Receiver

  1. Remove screws (1 – 6)
A black-and-white line drawing displays the front profile of a marine stereo receiver housing or cover with its lid flipped open, highlighting six screw locations labeled with black numbered circles 1 through 6. Right and Left Screws: 1: Located on the far-right outer edge of the inner housing frame. 6: Located on the far-left outer edge of the inner housing frame. Top Screws: 2: Located along the upper rim of the inner recess, on the left side. 4: Located along the upper rim of the inner recess, on the right side. Bottom Screws: 3: Located along the lower rim of the inner recess, on the left side. 5: Located along the lower rim of the inner recess, on the right side.
A black-and-white technical drawing illustrates attaching the front control knobs to a marine stereo receiver installed inside a protective housing. Housing & Receiver Unit: A single-DIN head unit with a display slot and five preset buttons sits secured within a flip-top marine splash guard housing. Knob Installation: Dashed alignment lines extend from two round control knobs at the top, showing them pushing downward onto the left and right control shafts protruding from either side of the stereo head unit.
  1. Remove the cover
  1. Connect the built-in cables to your radio/receiver(a.k.a. head unit)
  1. Insert radio
  1. Replace cover
  1. Replace screws
  1. Attach knobs

 

Single-Din Radio/Receiver

  1. Remove screws (1 – 6)
A black-and-white line drawing displays the front profile of a marine stereo receiver housing or cover with its lid flipped open, highlighting six screw locations labeled with black numbered circles 1 through 6. Right and Left Screws: 1: Located on the far-right outer edge of the inner housing frame. 6: Located on the far-left outer edge of the inner housing frame. Top Screws: 2: Located along the upper rim of the inner recess, on the left side. 4: Located along the upper rim of the inner recess, on the right side. Bottom Screws: 3: Located along the lower rim of the inner recess, on the left side. 5: Located along the lower rim of the inner recess, on the right side.
A black-and-white technical drawing shows the front view of a completed stereo installation inside a protective marine splash guard housing with an open lid. Housing Assembly: The outer housing holds an inner mounting frame secured with screws around the perimeter. Side adjustment knobs are visible on the exterior left and right walls. Stereo Faceplate Controls: Two stacked circular control knobs are located on the left side of the faceplate. A wide display screen occupies the top-center portion of the panel. A row of six horizontal buttons spans beneath the display screen.
  1. Remove the cover
  1. Connect the built-in cables to your radio/receiver(a.k.a. head unit)
  1. Insert radio
  1. Replace cover
  1. Replace screws
  1. Attach knobs

 

 

 

 

 
 


 

Related articles

Comments

0 comments

Please sign in to leave a comment.

Powered by Zendesk