ROCKPAR50: How To Set Up w/ A DMX Controller

Introduction

The Rock PAR 50 wash light can be controlled using a DMX controller, allowing for precise lighting control in stage productions, live performances, and DJ setups. This guide will take you through the step-by-step setup of your Rock PAR 50 with a DMX controller, including both wired and wireless DMX configurations.

What You Need

• DMX Controller
• DMX Cables
• Rock PAR 50 Wash Lights
• Wireless DMX Receiver (optional)

Step 1: Connecting the DMX Controller to the Light

1. Take a DMX cable and plug the male end into the DMX Out port on your controller.
2. Plug the other end into the DMX In port on your first Rock PAR 50 light.
3. For multiple lights, daisy chain them:
   • Take another DMX cable and connect the DMX Out of the first light to the DMX In of the second light.
   • Repeat this process for additional lights.

Step 2: Setting the DMX Channel Mode

The Rock PAR 50 offers two DMX channel modes:

• 3-Channel Mode: Controls only the red, green, and blue LEDs.
• 6-Channel Mode: Adds advanced lighting effects.

Setting the DMX Channel Mode

1. Press the Mode button on your light.
2. Scroll to the desired setting:
   • A001 for 3-Channel Mode.
   • D001 for 6-Channel Mode.
3. Use the Up/Down buttons to set the DMX address (e.g., 001).
4. Press Enter to save the setting.

🔹 Tip: Ensure all lights in your setup match the same DMX mode and address.

Step 3: Testing the DMX Controls

Once the lights are set to DMX mode, turn on the controller and activate Scanner 1.

6-Channel Mode Breakdown

• Mix colors by adjusting Faders 2-4.
• Enable strobe & chase modes by adjusting Fader 5.
• Control the speed of effects using Fader 6.

💡 Tip: The controller's LED display shows fader values, helping you fine-tune effects.

Step 4: Setting Up Wireless DMX (Optional)

For a wireless setup, you can use a Rockville DMX WR Wireless Receiver.

Configuring the Wireless DMX System

1. Turn on the Wireless DMX feature on the back of your controller.
2. Set the wireless DMX signal color:
   • Press the button under the LED light to cycle through colors.
   • Choose a color (e.g., Blue).
3. Turn on the wireless receiver:
   • Use a small item (like a screwdriver) to press the power button.
   • The LED indicator should light up.
4. Match the signal color:
   • Press the button on the receiver until it matches the controller’s color.
5. Check connectivity:
   • The receiver’s LED should flash green, and the controller’s LED should flash red.
6. Plug the receiver into the DMX In port of your first light.
7. Control the light wirelessly from your DMX controller.

📌 Note:

• Use one receiver per light OR
• Use one receiver for the first light and connect additional lights using DMX cables.

Conclusion

Setting up a DMX controller with your Rock PAR 50 lights allows for precise lighting control in any performance or event. Whether using wired or wireless DMX, you can customize your lighting to match your needs.