RAMSYS12: How To Set Up w/ a Mixer

Introduction

Using a mixer with your Rockville RAMSYS12 active speakers allows you to connect multiple microphones and instruments for live performances, band practices, and events. In this guide, we’ll cover:

• Connecting the mixer to the speakers
• Adjusting the mixer and speaker settings
• Expanding your setup with additional speakers or subwoofers

Whether you're setting up for a small event or a large venue, this step-by-step guide will help you get the most out of your Rockville RAMSYS12 speakers.

Step 1: Gathering the Required Cables

To connect the mixer to your RAMSYS12 speakers, you’ll need: 

Two XLR cables (for stereo sound)A microphone (optional for testing)

Step 2: Connecting the Mixer to the Speakers

1. Locate the main XLR outputs on your mixer (usually labeled as Main Out or L/R Outputs).
2. Take the female ends of the XLR cables and plug them into the main XLR outputs on your mixer.
3. Take the other (male) ends of the XLR cables and plug them into the XLR Line Inputs on both RAMSYS12 speakers.

Tip: If you're using just one speaker, connect the XLR cable from the mixer's Left (L) output to the XLR input on the speaker.

Step 3: Powering On and Adjusting Volume

1. Turn on the mixer before turning on the speakers.
2. Set the Line Level knobs on the RAMSYS12 speakers to about 50% (12 o’clock position).
3. Raise the Main Mix knob on your mixer to increase the overall volume.

Step 4: Connecting a Microphone (For Testing)

To test your setup, follow these steps:

1. Plug a microphone into Channel 1 on your mixer using an XLR cable.
2. Raise the Gain knob slightly on Channel 1.
3. Increase the Level knob for Channel 1.
4. Raise the Main Mix knob on your mixer.
5. Turn on the microphone and speak—your voice should now be heard through the RAMSYS12 speakers.

Step 5: Expanding Your Setup (Optional)

You can connect additional speakers or subwoofers to expand your setup.

Option 1: Adding More Speakers

• Use the Line Output on the RAMSYS12 speaker to daisy-chain additional speakers.
• Connect an XLR or 1/4” cable from the Line Output of the first speaker to the Line Input of the next speaker.

Option 2: Adding a Subwoofer

• Connect the XLR output from the mixer or the Line Output from the RAMSYS12 speaker to the input on a powered subwoofer.
• Adjust the subwoofer’s crossover and volume settings to match your system.

Step 6: Final Adjustments

1. Balance levels for microphones and instruments.
2. Adjust EQ settings on your mixer for better sound clarity.
3. Test and fine-tune your setup before your event.

Conclusion

Setting up a mixer with your Rockville RAMSYS12 speakers is quick and easy, providing powerful, clear sound for your performances and events.

Key Takeaways

Use XLR cables to connect the mixer to the speakers.

Adjust gain, level, and master volume for best sound quality.

Expand your system with additional speakers or subwoofers.

Test your setup before your event.