PIXEL HYBRID BAR: How To Position & Mount

Introduction

The Rockville Pixel Hybrid Bar is a versatile lighting fixture that can be positioned in various ways for wall washing, DJ setups, and truss mounting. This guide will show you how to adjust the light’s position, set it up on the floor, and mount it to a truss using clamps.

Adjusting the Light’s Angle

The Pixel Hybrid Bar features adjustable feet on each side, allowing you to set the angle as needed.

Steps to Adjust the Angle:

1. Locate the knobs on each foot of the light.
2. Loosen the knobs to allow movement.
3. Adjust the angle to your preference.
4. Tighten the knobs back up to lock it in place.

Floor Placement Options

You can position the Pixel Hybrid Bar on the floor for wall washing or DJ facade lighting.

1. Flat Against the Wall

• Place the light flush against the wall for maximum wall wash coverage.

2. Angled for Spread Lighting

• Position the light a few inches away from the wall.
• Adjust the feet to tilt the beam upwards.
• This method allows for a more even and widespread wash.

Mounting to a Truss

If you want to mount your Pixel Hybrid Bar to a truss, you'll need two LC70 lighting clamps.

Steps to Mount the Light:

1. Detach the Clamp Hardware
   • Remove the wing nut and unscrew the bolt from the clamp.
2. Attach the Clamps to the Light
   • Line up the clamp’s hole with the mounting holes on the light’s feet.
   • Insert the bolt through both holes.
   • Tighten the bolt and secure it with the wing nut.
3. Secure the Light to the Truss
   • Loosen the butterfly screws on the clamps.
   • Position the clamps around an open section of the truss.
   • Tighten the butterfly screws to lock the light in place.
4. Adjust the Angle After Mounting
   • Use the knobs on the feet to set the light at the desired angle.
   • Once positioned, tighten the knobs to secure the angle.

Conclusion

The Rockville Pixel Hybrid Bar offers multiple positioning options, making it perfect for stage lighting, DJ facades, and event setups. Whether you’re using it for wall washing on the floor or mounting it to a truss, these steps will help you set up the light with ease.