ROCK BEAM DC: How To Position

Introduction

In this guide, we will walk you through the different ways you can position and mount your Rock Beam DC light. Whether you're setting it up on a surface, using it for wall washing, or mounting it on a truss, this tutorial will ensure you're able to set up your light in the best possible way for your event or performance.

1. Positioning the Light on a Surface

Using the Rubber Feet

• The Rock Beam DC light is designed with rubber feet on the bottom, allowing you to place it on any flat surface.
• It works well on:
  • A table or totem stand
  • The floor for wall-washing effects

Wall-Washing Setup

• For wall washing, you have two options:
  1. Place the light flush against the wall to project the light directly upwards.
  2. Place the light a few feet away from the wall to change the angle of the light and create a different visual effect.

2. Mounting the Light on a Truss

Attaching the Mounting Bracket to the Lighting Clamp

1. Remove the Bolt and Butterfly Nut:
   • Start by removing the bolt at the bottom of the lighting clamp and the butterfly nut.
2. Attach the Mounting Bracket:
   • Line up the hole on the mounting bracket to the hole on the bottom of the lighting clamp.
   • Insert the bolt through both holes, securing them together.
   • Use the butterfly nut to tighten the bolt, ensuring the bracket is secure.

Attaching the Bracket to the Light

1. Remove the Screws on the Bottom of the Light:
   • Use a screwdriver to remove the two screws on the bottom of the light, which are used to attach the mounting bracket.
2. Mount the Bracket:
   • Once the screws are removed, take the mounting bracket and clamp setup and line up the holes on the bracket to the holes on the light.
   • Re-insert the screws and tighten them with a screwdriver to secure the bracket in place.

3. Mounting the Light to the Truss

Mounting Process

1. Loosen the Butterfly Screw:
   • Loosen the butterfly screw on the lighting clamp to create enough space for it to fit onto the truss.
2. Position the Clamp on the Truss:
   • Find the desired spot on the truss where you want to mount the light.
   • Line up the clamp with the truss and tighten the butterfly screw to secure the clamp.

Cable Considerations

• Ensure you have long enough DMX and power cables to run from the light to your DMX controller or power supply.
• Make sure the cables are properly routed to avoid any interference or obstruction.

4. Conclusion

Setting up and positioning your Rock Beam DC light is simple, whether you want to place it on a surface for a quick setup or mount it to a truss for more advanced applications. With the included mounting bracket and hardware, you're ready to create dynamic lighting effects for any event or performance.