RVSS4AB: How To Attach A Lighting Crossbar

Introduction

This guide will walk you through the steps to attach a lighting crossbar to your Rockville RVSS4A speaker stand. Using a lighting crossbar like the RCS52, you can mount multiple lights onto a single stand for stage performances, DJ setups, or event lighting.

What You’ll Need

• Rockville RVSS4A Speaker Stand
• Lighting Crossbar (e.g., Rockville RCS52)
• Mounting Hardware (Screws or Lighting Clamps, if required)

Step 1: Preparing the Stand

1. Loosen the front adjustment knob on the stand.
2. Press the Air Assist Button to lift the stand one notch—this provides space for mounting the crossbar.

Step 2: Attaching the Lighting Crossbar

1. Loosen the knob on the side of the lighting crossbar.
2. Align the bottom hole of the crossbar with the pole on top of the stand.
3. Slide the crossbar onto the stand until fully seated.
4. Tighten the side knob to secure the crossbar in place.

Step 3: Mounting Lights onto the Crossbar

1. If using the RCS52: Attach lights using the included screws.
2. If using a different crossbar: Use lighting clamps to secure lights.
3. Ensure all lights are evenly distributed for balance.

Step 4: Adjusting the Height

1. Once lights are attached, press the Air Assist Button to raise the stand to the desired height.
2. Tighten the front adjustment knob to lock the stand in place.

Tip: The RVSS4A stand supports up to 154 lbs—make sure the total weight of your lights does not exceed this limit.

Conclusion

Attaching a lighting crossbar to your RVSS4AB stand is simple and allows you to mount multiple lights efficiently. Whether using lightweight or heavier fixtures, the air-assist feature makes height adjustments effortless.