Introduction
This guide will walk you through setting up the Master-Slave function for your Party Spinner LED Moving Headlights. This function allows multiple lights to synchronize with a single master light, following its effects and settings. You can control the lights using DMX cables or the included remote.
Step-by-Step Instructions
1. Choose a Master Light
- Decide which one of your Party Spinner LED Moving Headlights will act as the Master light.
- Set it to Master mode in the menu settings.
2. Set Other Lights to Slave Mode
- For all other lights in the setup, go to the menu and set them to Slave Mode 1.
3. Connect the Lights Using DMX Cables
- Connect the Master to the First Slave Light:
- Take a DMX cable.
- Plug the male end into the DMX Out of the Master light.
- Plug the other end into the DMX In of the first Slave light.
- Chain Additional Slave Lights:
- Use additional DMX cables.
- Connect DMX Out from the first Slave light to DMX In on the next light.
- Repeat this process for all lights in your chain.
4. Controlling the Lights
You can control the lights using the Master light’s menu or the included remote.
A. Controlling with the Master Light
- Once all lights are connected, set the Master light to any mode.
- The Slave lights will automatically follow.
B. Controlling with the Remote
The included remote allows you to:
- Turn Lights On/Off
- Select Modes:
- Auto
- Fade
- Strobe
- Sound-Activated
- Static Color
- Switch Between Master and Slave Mode
- Select Colors:
- Red, Green, Blue, White, Amber, Ultraviolet
- Orange, Cyan, Pink
- Adjust Brightness with Up/Down Arrows
- Set DMX Address/Channel
Conclusion
Setting up Master-Slave mode for your Party Spinner LED Moving Headlights is quick and easy. By using DMX cables or the remote control, you can synchronize multiple lights effortlessly. Whether you're creating a dynamic light show or a coordinated stage setup, this setup provides seamless operation.
Comments
0 comments
Article is closed for comments.