WET PAR 50: How To Use The Remote

Introduction

In this guide, we will explain how to use the remote control to operate the Rockville WET PAR 50 PAR lights. You'll learn how to control brightness, switch between groups of lights, change colors, and activate different lighting modes.

Step 1: Setting Up Remote Groups

The WET PAR 50 remote can control multiple groups of lights. Here's how to assign and switch between groups:

1. Assigning Remote Groups:
   • Navigate to the Remote Settings on the first group of lights.
   • Select REM1 for this group.
   • On the second group of lights, go to Remote Settings and select REM2.
2. Switching Between Groups:
   • To switch between the two groups, hold down the Brightness button on the remote.
   • The LED indicator on top of the remote will flash once.
   • Keep holding until it flashes quickly—this means the remote has successfully switched to the next group.

Step 2: Remote Control Functions

Once the groups are set, you can use the remote for various functions:

Brightness Control

• Increase or decrease brightness using the brightness buttons.
• Switch between groups by holding the brightness buttons until the LED flashes.

Power Control

• ON/OFF buttons allow you to turn the lights on or off.

Color Selection

• Select static colors directly from the remote:
  • Red
  • Green
  • Blue
  • White
  • Amber
  • Ultraviolet (UV)
• Use the number buttons to access additional color options.

Lighting Modes

• The remote includes several preset modes:
  1. Sound Mode: Syncs lights to music and sound.
  2. Strobe Mode: Creates a flashing effect.
  3. Snap Mode: Instantly changes between colors.
  4. Fade Mode: Gradually blends between colors.
  5. Auto Mode: Runs through built-in light programs.
• While in any mode, you can adjust the speed using the brightness buttons.

Conclusion

The Rockville WET PAR 50 remote makes it easy to control multiple groups of lights, adjust brightness, select colors, and activate different lighting modes.