DMAC65 | DMAC80: How To Set Up

Introduction

The DMAC65 and DMAC80 Wakeboard Tower Speaker Pods are perfect for enhancing your boat’s audio system. These marine-grade speaker pods are designed to provide high-quality sound while withstanding both fresh water and salt water environments. Whether you're using the 6.5-inch or 8-inch versions, the setup process is the same.

In this guide, we will walk you through the setup process for the DMAC65 speaker pods, but the steps are also applicable to the DMAC80.

Requirements

• DMAC65 or DMAC80 speaker pods
• Speaker wire
• Allen key (included)
• Rubber inserts (included)
• Two speakers (for the dual pods)
• Marine-grade amplifier or audio source (not included)

Step-by-Step Instructions

1. Unboxing and Components Overview

• Open the box and make sure you have the following:
  • Two aluminum speaker cans (6061 aircraft-grade aluminum, fully marinized)
  • Six rubber inserts (for mounting the pods on the bar)
  • Two Allen keys (for assembling the pods)
  • Metal spacers for securing the speaker pods

2. Assembling the Pod

• Step 1: Start by taking the clamp and center piece and align the holes on both pieces.
• Step 2: Use the longer Allen screws and the larger Allen key to secure the clamp to the center piece. Tighten them until they are securely in place.

3. Attaching the Speaker Pod to the Clamp

• Step 1: Take one of the speaker pods and align the holes on the speaker pod with the holes on the center piece.
• Step 2: Insert one of the metal spacers into the pod and line it up with the holes.
• Step 3: Secure the pod by running two Allen screws through the spacer and into the center piece. Use the smaller Allen key to tighten the screws.

4. Running the Speaker Wires

• Step 1: Before attaching the speakers, run the speaker wire through the opening at the center of the pod.
• Step 2: Once the wires are inside the pod, connect them to the terminals on your speakers.

5. Mounting the Speakers

• Step 1: Align the speakers with the holes along the lip of the pods.
• Step 2: Secure the speakers by using screws to attach them to the pod.
• Tip: If the holes don’t align perfectly with your speakers, you can drill new holes to ensure a secure fit.

6. Mounting the Speaker Pod to the Tower

• Step 1: Loosen the Allen screws at the top of the pod’s clamp.
• Step 2: Add the rubber inserts around the bar of the tower. These inserts are used to provide a snug fit for different-sized bars (the clamps fit bars ranging from 2 inches to 2.5 inches in diameter).
• Step 3: Place the pod over the bar and tighten the Allen screws to secure it in place.

Troubleshooting & FAQs

1. What if the speaker doesn’t fit the pod holes?

• You can drill new holes to accommodate the speaker. Just make sure to drill in areas where the speaker will be securely fastened and won’t move during use.

2. The speaker wire doesn’t seem to fit through the hole in the pod.

• Check if you’re using the correct wire gauge. If the wire is too thick, consider using a thinner wire or adjusting the hole for a better fit.

3. How do I know which speaker wires to connect?

• Follow the polarity instructions on the back of the speakers. Typically, red connects to positive and black to negative.

Conclusion

Setting up your DMAC65 or DMAC80 Wakeboard Tower Speaker Pods is simple and ensures your boat or outdoor setup has high-quality sound for any adventure. With just a few tools and the included hardware, you'll have your system up and running in no time.