MTRAY: How To Set Up w/ Mic & Desktop Stand

Introduction:
In this article, we will walk you through the simple process of setting up your MTRAY on either a microphone or desktop stand. This process is quick and easy, and you’ll have your equipment securely mounted and ready to use in just a few steps. Whether you're using the tray for mixers, interfaces, or other gear, this guide will show you how to attach and detach it efficiently.

Requirements:

• MTRAY
• Microphone or desktop stand
• Your gear (e.g., mixers, interfaces, headphone amps)

Step-by-Step Instructions:

1. Loosen the Knob

• Start by loosening the knob on the MTRAY. This will allow you to adjust the clamp, making it easier to attach to your stand.

2. Check for Enough Space

• As you loosen the knob, check to make sure there’s enough space to open the clamp fully. If not, loosen it further until you have the necessary room.

3. Adjust the Clamp Size

• The clamp is adjustable, so you can modify its width to fit the stand. Ensure that the circular ridges on the clamp align with the stand to ensure a secure fit.

4. Attach the Tray to the Microphone Stand

• Line the clamp up with the desired spot on the microphone stand, whether it’s closer to the top or bottom. Once aligned, tighten the knob to secure the tray in place. Make sure the knob is tightened all the way to ensure the tray is securely attached.

5. Add Your Items

• Once the tray is attached and secured, place your gear—like mixers, interfaces, or headphone amps—onto the tray.

6. Removing the Tray from the Microphone Stand

• To remove the tray, simply loosen the knob again to release the clamp. Once the clamp is loose enough, you can slide the tray off the stand.

7. Attaching the Tray to a Desktop Stand

• The process for attaching the tray to a desktop stand is the same. Loosen the knob to create enough space for the clamp, line it up with the desktop stand, and then tighten the knob to secure it.

8. Add Your Items to the Desktop Stand

• After securing the tray on the desktop stand, you can place your items, like an interface or headphone amp, on the tray. This setup is perfect for podcasts or studio work, allowing you to keep everything organized.

9. Removing the Tray from the Desktop Stand

• To detach the tray from the desktop stand, simply loosen the knob again and remove the tray once the clamp is open.

Conclusion:
Setting up your MTRAY on a microphone or desktop stand is a straightforward process. With just a few simple steps, you can have your items mounted securely, whether you’re using the tray for audio equipment, interfaces, or more.