MTRAY: How To Set Up w/ Laptop Stand

Introduction:
In this article, we will guide you through the simple process of attaching your MTRAY to a laptop stand. This process is easy to follow and does not require any technical experience. You'll be able to set up your tray and laptop stand in no time. Whether you're setting up your laptop for work or performance, these steps will ensure a smooth and secure setup.

Requirements:

• MTRAY
• Laptop stand
• Your items (mixers, MIDI controllers, etc.)
• A knob for securing the tray

Step-by-Step Instructions:

1. Loosen the Knob

• Begin by loosening the knob on the MTRAY to open up the clamp. This will allow you to attach the tray to your laptop stand.

2. Check the Clamp Fit

• Check that you have enough room on the stand for the clamp to fit. If the clamp doesn't fit properly, continue loosening the knob until it opens wide enough.

3. Position the Clamp

• Position the clamp at the desired location on the stand. If you prefer to attach it to a thicker part of the stand, simply line the clamp up with that section.

4. Attach the Tray to the Stand

• Push the clamp onto the stand, ensuring that it fits securely. Once it’s in place, tighten the knob to secure the clamp onto the stand.

5. Place Your Items on the Tray

• Now that the tray is secured, place your mixers, MIDI controllers, or any other items you need for your setup.

6. Removing the Tray

• To remove the tray, loosen the knob again to release the clamp. If the tray was attached to a thicker section of the stand, simply push on the clamp to remove the tray.

7. Attaching to a Thinner Stand

• If you need to attach the tray to a thinner part of your stand, repeat the same steps, but you won't need as much force to fit the clamp.

Conclusion:
Setting up your MTRAY on your laptop stand is a quick and simple process. With just a few easy steps, you can have your items ready to go.