R-BOOM 34: How To Set Up & Use

Introduction

This guide will walk you through setting up the Rockville R Boom 34 Easy Adjust Boom Arm. Whether you're using it for a dynamic or condenser microphone, this step-by-step guide will ensure a secure and organized setup. You’ll also learn how to attach a pop filter and even mount a smartphone or tablet.

What's Included

• Boom arm
• Table clamp
• Base to connect the arm to the clamp
• Mic clip with a removable thread adapter
• Wire management strips

Step-by-Step Setup

1. Attaching the Clamp and Base

1. Take the clamp and base and align the top part of the clamp with the slit on the base.
2. Push it in until you hear a click.

2. Connecting the Boom Arm

1. Loosen the knob on the base slightly—just enough for the boom arm to fit.
2. Insert the bottom of the boom arm into the hole on the base.
3. Tighten the knob to secure the boom arm.

3. Mounting the Boom Arm to a Table or Desk

1. Loosen the bolt at the bottom of the clamp.
2. Position the clamp on your desired desk or table location.
3. Tighten the bolt to secure it in place.

4. Adjusting the Boom Arm

• Use the knobs on the side of the arm to adjust its position:
  • The bottom knob adjusts the lower section.
  • The top knob adjusts the upper section.
  • The knob at the top adjusts the microphone angle.

Attaching a Microphone

Using a Dynamic Microphone

1. Ensure the mic clip has the attachment piece installed for compatibility.
2. Line up the mic clip's threading with the threading on the boom arm.
3. Tighten it to lock it in place.
4. Insert your dynamic microphone into the clip.
5. Connect an XLR cable:
   • Plug the female end into the microphone.
   • Secure the cable along the stand using the wire management strips.

Using a Condenser Microphone with a Shock Mount

1. Most shock mounts require the thread adapter. Install the attachment piece first.
2. Thread the shock mount onto the boom arm and tighten.
3. Pinch the shock mount arms and insert your condenser microphone.
4. Connect the XLR cable and run it along the boom arm using the wire management strips.

Optional Add-ons

Attaching a Pop Filter

1. Loosen the bolt on the pop filter's clamp.
2. Position the clamp on the boom arm so the filter reaches the mic.
3. Tighten the bolt to secure it.
4. Adjust the filter so it's a few inches from the microphone.

Mounting a Smartphone or Tablet with the iStand 22

1. Attach the mic clip adapter to the iStand 22.
2. Screw the iStand onto the boom arm.
3. Secure your smartphone or tablet in the iStand.
4. Run your charging cable along the boom arm using wire management strips.

Final Steps

• Ensure all connections are tight.
• Adjust the boom arm to the perfect position.
• Connect the microphone to a mixer or interface for recording.

Conclusion

The Rockville R Boom 34 Easy Adjust Boom Arm is easy to set up and provides a stable, adjustable mount for your microphone or device. Whether you’re using a dynamic or condenser microphone, adding a pop filter, or mounting a tablet, following these steps ensures a smooth experience.