Inputs, Outputs, and Controls On Your Insta Party 51 Explained:

Introduction

This article explains how to mount your Rockville InstaParty 51 using the included mounting bracket and your choice of either the C-clamp or the magnet clamp.

The steps are simple and easy to follow, even if you have no technical experience.

Requirements

• Rockville InstaParty 51 light
• Included mounting bracket
• Included knob screws (to secure the bracket to the light)
• Either the included C-clamp or the included magnet clamp
• A truss or speaker stand (for C-clamp mounting), or a magnetizable surface (for magnet clamp mounting)

Step-by-Step Instructions

1) Attach the mounting bracket to the light

1. Locate the mounting bracket and the knob screws.
2. Line up the mounting bracket with the mounting holes on each side of the light.
3. Insert the knob screws into the holes on both sides.
4. Tighten the knob screws to secure the bracket onto the light.

2) Choose your mounting option

You have two ways to mount the light once the bracket is attached:

• C-clamp: For traditional mounting on a truss or speaker stand
• Magnet clamp: For mounting on any surface that is magnetizable

3) Mount the light using the C-clamp (truss or stand)

1. Remove the nut and washers from the C-clamp bolt.
2. Attach the C-clamp to the bracket by aligning the bolt with the bracket’s mounting point.
3. Reinstall the washers and nut onto the bolt.
4. Tighten the nut until the clamp is secure on the bracket.
5. Loosen the clamp bolt to open the clamp until there is enough space to fit your truss or speaker stand.
6. Position the clamp on the truss or stand.
7. Tighten the clamp bolt to secure the light onto the truss or stand.

4) Mount the light using the magnet clamp (magnetizable surface)

1. Loosen and remove the nut and washers on the magnet clamp.
2. Feed the magnet clamp bolt through the hole in the middle of the mounting bracket.
3. Reinstall the washers and nut.
4. Tighten everything to secure the magnet clamp onto the bracket.
5. Attach the light to a magnetizable surface.

Troubleshooting and FAQs

The bracket feels loose after installation

• Make sure both knob screws are tightened evenly.
• Recheck that the bracket is properly aligned with the mounting holes on both sides of the light.

The clamp does not feel secure on the bracket

• Confirm the washers and nut are installed correctly on the clamp bolt.
• Tighten the nut until the clamp is firmly secured to the bracket.

The light shifts after mounting

• For the C-clamp, tighten the clamp bolt more to secure the light to the truss or stand.
• For the magnet clamp, make sure the mounting surface is magnetizable, flat, and clean so the magnet can grip securely.

Conclusion

To mount your InstaParty 51, attach the mounting bracket using the knob screws, then choose either the C-clamp for a truss or stand, or the magnet clamp for a magnetizable surface.