K-GO: How To Set Up The Microphone

Introduction: 

The Rockville KGO Portable Speaker offers fun and easy ways to enhance your audio experience, including microphone setup and various sound effects. This guide will walk you through setting up your microphone, adjusting its volume, and using the built-in effects to take your sound to the next level.

Step-by-Step Instructions:

1. Powering On the Microphone

• Step 1: Hold down the power button on the microphone until the blue light appears.
• Step 2: Once the light is on, the microphone is ready to use. You’ll hear your voice through the speaker.

2. Adjusting the Microphone Volume

• Step 1: Tap the plus (+) button to increase the microphone volume.
• Step 2: Tap the minus (-) button to lower the volume.
  • Note: Do not press and hold the buttons as this may not adjust the volume.

3. Applying Effects to Your Voice

The microphone has several built-in effects you can switch between using the effects button on the microphone.

• Reverb Effect
  • Press the effects button to activate Reverb.
  • You’ll hear the speaker announce “Reverb,” and the effect will be applied to your voice.
  • Example: "Check one two."
• High Pitch Effect
  • Press the effects button again to activate the High Pitch effect.
  • This raises the pitch of your voice, creating a fun high-pitched sound.
  • Example: "Check one two." (Your voice will sound much higher.)
• Voice Cancel Effect
  • Press the button to activate Voice Cancel. This removes vocals from songs, allowing you to sing over the track.
  • To test it, play a song with vocals, then press the button. The vocals of the track will be reduced or canceled.
  • Example: "Check one two." (Your voice is now over the music track.)
• Auto Pitch Effect
  • Press again for Auto Pitch, which adjusts your voice for pitch correction.
  • Example: "Hello, hello." (Your voice will sound automatically corrected.)
• Low Pitch Effect
  • Press to activate Low Pitch for a deep voice effect.
  • Example: "Check one two." (Your voice will sound much lower.)
• Flat Effect
  • Finally, press the effects button to return to the Flat effect (normal voice).
  • Example: "Check one two."

4. Disconnecting the Microphone

• Step 1: To disconnect the microphone, quick-press the power button.
• Step 2: You’ll hear the speaker say “Microphone off,” and your voice will no longer be heard through the speaker.

5. Reconnecting the Microphone

• Step 1: To reconnect, quick-press the power button again.
• Step 2: You’ll hear “Microphone on,” and the microphone will be reconnected.

6. Turning the Microphone Off Completely

• Step 1: Hold down the power button until the blue light disappears.
• Step 2: Once the light goes out, the microphone is completely off.

Conclusion:

Setting up and using the microphone on your KGO Portable Speaker is simple and adds a fun element to your audio experience. You can easily apply different effects, adjust the volume, and disconnect/reconnect as needed.