RPB50: How To Set Up & Use

Introduction:

This article provides a step-by-step guide on how to set up and use the Rockville RPB50 Portable LED Bluetooth Speaker. Whether you’re connecting via Bluetooth, AUX, USB, or TF card, or syncing two units using TWS (True Wireless Stereo), the steps below make it easy for anyone to get started—no technical experience required.

What You’ll Need:

• Rockville RPB50 Speaker
• Included USB-C to USB-A charging cable
• Included 1/8” AUX cable
• Smartphone, tablet, or audio player

Step-by-Step Instructions

1. Charging the Speaker

1. Remove the rubber cover on the back of the speaker.
2. Plug the USB-C end of the charging cable into the speaker.
3. Plug the USB-A end into a wall charger or power bank.
4. A full charge gives up to 16 hours of playback time.

2. Powering On

• Press and hold the power button (located on top of the speaker) until you hear “Power On”.

3. Connecting Audio Sources

Input Options on the Back of the Speaker:

• TF Card
• USB Drive
• AUX (1/8" input)

To switch between input modes:

• Short press the power button to cycle through TF, USB, AUX, and Bluetooth modes.

Using AUX Mode:

1. Plug one end of the AUX cable into the speaker’s AUX input.
2. Plug the other end into your MP3 player or device.
3. Short press the power button to switch to AUX mode.

4. Bluetooth Pairing

1. Turn on the speaker. If no other source is connected, it defaults to Bluetooth mode.
2. If needed, short press the power button until you hear "Bluetooth mode."
3. Open the Bluetooth settings on your smartphone or tablet.
4. Select RPB50 from the list.
5. Once paired, you’ll hear a confirmation tone.

5. Using the Control Buttons (Top of Speaker)

• Volume Up/Down: Short press to adjust volume. Long press to skip tracks.
• Play/Pause: Short press to play or pause music. Also used to answer calls when connected to a phone.
• LED Button:
  • Short press to cycle through LED modes (color changes, color wheel, sound-reactive).
  • Long press to turn LEDs off completely.

6. Pairing Two Speakers with TWS Mode

If you have two RPB50 speakers, follow these steps for True Wireless Stereo:

1. Ensure no Bluetooth devices are connected to either speaker.
2. Turn on both speakers.
3. Choose one speaker to be the master unit.
4. On the master speaker, double-tap the power button.
5. Wait for a pairing confirmation sound.
6. Go to your phone’s Bluetooth settings and pair with RPB50.
7. To confirm they’re paired, press the LED button on the master speaker—if both speakers' lights change, pairing was successful.

7. Powering Off

• Hold down the power button to turn off the speaker when finished using it.

Troubleshooting & FAQs

Q: My speaker won't charge. What should I check?

• Ensure the USB-C cable is securely connected. Try a different wall charger or USB port.

Q: The Bluetooth won’t pair. What can I do?

• Make sure the speaker is in Bluetooth mode and not already connected to another device. Unpair from other devices and try again.

Q: I don’t hear sound from both speakers in TWS mode.

• Ensure you double-tapped the power button on the master speaker and confirmed LED sync between both units.

Q: Can I turn off the LED lights?

• Yes, hold the LED button until the lights turn off.

Conclusion:

Setting up your Rockville RPB50 Portable LED Bluetooth Speaker is quick and easy. With multiple input modes, Bluetooth compatibility, and TWS pairing, you can enjoy your music in various ways.