ACC-B: How To Attach Lights

Introduction

The Rockville ACC-B T-Bar is designed to securely mount your PAR lights, wedge lights, and other lighting fixtures for stage, DJ, and event setups. This guide will walk you through how to attach different types of lights using the included hardware.

What You’ll Need

• ACC-B T-Bar
• Included hardware (screws, wing nuts, washers)
• PAR or wedge lights with mounting brackets

Step 1: Attaching a PAR Light

1. Remove the Wing Nut and Washer:
   • Take off one washer and place it aside.
   • Remove the wing nut and keep it nearby.
2. Insert the Screw into the T-Bar:
   • Run the screw through one of the holes in the T-Bar arm.
3. Attach the PAR Light Bracket:
   • Align the bracket’s mounting hole with the screw.
   • Push the screw through the bracket.
4. Secure with a Wing Nut:
   • Place the washer back onto the screw on the opposite end.
   • Tighten the wing nut to secure the light.

Step 2: Attaching a Wedge Light

1. Remove the Wing Nut and One Washer:
   • You won’t need the wing nut for this setup.
   • Set aside one of the washers.
2. Insert the Screw into the T-Bar:
   • Push the screw through a hole in the T-Bar arm.
   • Add the washer back onto the screw on the opposite end.
3. Align the Wedge Light with the Screw Hole:
   • Match the light’s mounting hole with the screw on the T-Bar.
4. Secure the Light:
   • Tighten the screw into the wedge light’s built-in hole.

Step 3: Mounting Additional Lights

• Follow the same process for each additional PAR or wedge light.
• Ensure all lights are securely attached and evenly spaced for balance.

Conclusion

Attaching lights to your Rockville ACC-B T-Bar is quick and simple. Whether using PAR lights with brackets or wedge lights with built-in mounting holes, the included hardware makes installation secure and hassle-free.