ACC-B: How To Break Down

Introduction

When it’s time to pack up and hit the road, properly breaking down your Rockville ACC-B T-Bar ensures that your equipment stays safe and organized. This guide will walk you through step-by-step instructions on how to disassemble and store your T-Bar and lights.

Step 1: Removing the Lights

1. Loosen the Wing Nut:
   • On each PAR or wedge light, loosen the wing nut that secures it to the T-Bar.
2. Remove the Light:
   • Carefully slide the light out from the mounting hole.
   • Hold onto the washers and screws to avoid losing them.
3. Secure the Hardware:
   • If desired, reattach the washer and wing nut onto the screw for easy reassembly.
4. Repeat for All Lights:
   • Follow the same steps for each additional light.
   • If any screws are too tight, use a wrench to hold them in place while loosening.

Step 2: Folding Down the T-Bar Arms

1. Lower One Arm at a Time:
   • Remove the safety pin from one arm.
   • Gently lower the arm back to the center position.
   • Reinsert the safety pin to lock it in place.
2. Repeat for the Second Arm:
   • Take out the second safety pin, lower the arm, and reinsert the pin.

Step 3: Removing the T-Bar from the Stand

1. Loosen the Side Knob:
   • Locate the side knob that secures the T-Bar to the stand.
   • Turn it counterclockwise to loosen.
2. Lift Off the T-Bar:
   • Once loosened, carefully lift the T-Bar off the stand.

Step 4: Storing the T-Bar in the Included Bag

1. Open the Carrying Bag.
2. Place the T-Bar Inside the Bag.
3. Secure the Bag for Transport.

Conclusion

Breaking down your Rockville ACC-B T-Bar is quick and easy, ensuring safe storage and easy transport for your next gig or event. By keeping your hardware organized and properly securing your lights, setup at your next show will be just as smooth.