HP65S | HP65S-8: How To Set Up & Use

Introduction

The Rockville HP65S Black Speakers are designed for wall-mounted installations, offering versatile positioning and easy connectivity to a receiver. This guide will walk you through the mounting process, wiring setup, and connection to your receiver for the best audio experience.

1. What’s Included in the Box?

✔ (2) HP65S Black Speakers
✔ (2) Mounting Brackets (one per speaker)
✔ (4) Knobs (two per speaker) for attaching speakers to the bracket
✔ Foam Pads (for the top of the mounting brackets)
✔ Speaker Wire (to connect speakers to the receiver)
✔ Mounting Hardware (screws and anchors)

2. Mounting the Speakers to a Wall

Choosing the Right Mounting Location

• If mounting to drywall: Use ¼-inch screws and ¼-inch anchors for a secure fit.
• If mounting to a stud: Anchors are not needed—just screw directly into the stud.
• Stud spacing: Typically 16 or 24 inches apart. Use a stud finder to locate them if needed.

Step-by-Step Mounting Instructions

1. Position the Mounting Bracket
   • Hold the mounting bracket against the wall in your desired location.
   • Ensure the bracket is positioned with the backward L shape facing up.
2. Mark the Drill Points
   • Using a pencil or pen, mark the holes where you will drill for screws.
   • You can also use additional holes at the top, middle, or bottom to run speaker wires through the wall.
3. Drill the Holes
   • Use a ¼-inch drill bit for ¼-inch anchors and screws.
4. Insert the Anchors (if needed)
   • If mounting on drywall, insert the anchors into the holes.
   • If the anchors don’t fit easily, use a hammer to tap them in.
5. Attach the Mounting Bracket
   • Line up the bracket with the drilled holes.
   • Secure the screws into the anchors using a drill.
6. Attach the Speaker to the Bracket
   • Line up the speaker’s top and bottom holes with the bracket.
   • Insert the screw knobs into these holes.
   • Tighten the knobs securely but not fully if you want to adjust the speaker angle.

Mounting Options

• Vertical Mounting: Align the bracket vertically and install the speaker.
• Horizontal Mounting: Rotate the bracket horizontally before installing the speaker.

3. Connecting the Speakers to a Receiver

Understanding Impedance & Connections

✔ The HP65S speakers are 4-ohm, meaning they are compatible with any 4-ohm receiver.
✔ One speaker should be connected per Left and Right channel on your receiver.
⚠ DO NOT connect two speakers per channel unless your receiver supports 2-ohm impedance.

Wiring Instructions

1. Loosen the Speaker Bracket Slightly
   • This allows access to the positive (+) and negative (-) terminals on the back of the speaker.
2. Connect the Speaker Wire to the Speaker Terminals
   • Press down on the terminals to insert the stripped ends of the speaker wire.
   • Match the polarity:
     • Red wire → Positive (+)
     • Black wire → Negative (-)
3. Run the Wires for a Clean Setup
   • Use the hole at the bottom of the bracket to organize your wires.
   • If mounting wires inside a wall, use the middle hole on the bracket for cable management.
4. Connect the Speaker Wire to the Receiver
   • Plug the other ends of the speaker wire into the receiver’s Left and Right channels.
   • Match polarity (Red to +, Black to -).

4. Testing & Adjustments

✔ Power on your receiver and play music to test the sound output.
✔ Adjust the speaker angles for optimal audio direction.
✔ If needed, fine-tune the bass, treble, or balance settings on your receiver.

Conclusion

By following these steps, your Rockville HP65S Black Speakers will be securely mounted and connected to your receiver for optimal performance.